Essential Digital Video Baby Monitor

panel upward (fig.3).Remove the 4 1.5V Alkaline AA/LR6batteries and replace them with 4similar batteries, taking care to respectthe proper insertion polarity asindicated in the battery compartment.Reposition the Alkaline battery compartmentclosing panel (10) first insertingthe lower panel hooks in theirbattery compartment housing andgently pushing the panel downward(fig.4).3.3 Installing the lithium-ion batterysupplied with the parent unit (primarilyin receiver mode)Upon purchase, the 3.7 V 1800mAhrechargeable lithium-ion battery (13)in the parent unit is kept separately inthe product packaging.Carefully remove the lithium-ion batteryfrom its packaging.Remove the rechargeable batterycompartment closing panel (10), placingyour finger near the top grooveand gently pulling the panel outward(fig.5).Insert the lithium-ion battery (13), respectingthe proper insertion polarityas indicated in the battery compartment.Reposition the rechargeable batterycompartment closing panel (13), firstinserting the lower panel hooks intheir battery compartment housingand gently pushing the panel towardthe product (fig.6).3.4 Replacing the lithium-ion batterysupplied with the parent unit(primarily in receiver mode)If the duration of the rechargeablelithium-ion battery is reduced excessively,this means that it has run outand therefore must be replaced (thisis to be considered normal becauserechargeable batteries run out overtime).Remove the rechargeable batterycompartment closing panel (10), placingyour finger near the top grooveand gently pulling the panel outward(fig.7).Remove the run out rechargeable battery(13) and replace with anotherrechargeable battery that is identicalto the 3.7V 1800mAh supplied withthe product (code20256600100 tobe requested directly from ArtsanaS.p.A.) taking care to place them withthe correct insertion polarity indicatedon the battery compartment.Reposition the rechargeable batterycompartment closing panel (10), firstinserting the lower panel hooks intheir battery compartment housingand gently pushing the panel towardthe product (fig.8).TECHNICAL SPECIFICATIONSBaby unit (primarily in transmittermode of images and sounds)Mod. 06626Power:Internal: FOUR 1.5V AA/LR6 ALKA-LINE BATTERIESExternal: via 100-240V~ 50/60Hz/6.5V 550mA mains switchingadapterTransmission:• Transmission frequency band: 2400-2454MHz• Signal strength: 100mW maxLED infrared radiation: emissions belowLEA Class 1, standard EN 60825-138