Notice_User-guide_293280-virax.pdf

USE - Fig. 15 to 16
Fig. 15 – Locking of the gun trigger
English
If, to shut down the electric supply or for whatever other reason, you have to put the gun down
while the equipment is switched on and under pressure , make sure that the trigger of the gun
is locked by means of the RED lever located behing the trigger.
Fig. 16 – REMINDER OF SAFETY INSTRUCTIONS during use
Do not direct the jet towards living beings.
If necessary, mark off a protected area of use.
Starting up in HP mode results in a strong recoil of the lance: Be sure
to hold it firmly when starting up.
Do not direct the high pressure jet towards a power supply or an
electrical device which is switched on (including the high pressure cleaner!).
DETERGENT - Fig. 17 to 18
Fig. 17– FILLING UP the detergent tank (capacity 7.5 l MAX):
Use a funnel to fill up the tank (in order not to splash the machine).
A detergent for HP cleaners is rarely used "pure":
It must always be diluted (with water) according to the written information.
For best results, chose and use only the detergent suitable for the purpose or the expected
results (Dégreasing ; Disinfectant...).
The following products are strictly forbidden for spraying:
� UNDILUTED ACIDS of a PH < 3.
� UNDILUTED BASIC PRODUCTS of a PH > 9.
� Inflammableproducts (Gasoline; Petrol, etc.).
Fig. 18 – RELEASE OF THE DETERGENT :
Use of the detergent is only possible at LOW PRESSURE hence only with the 2
CHANNEL lance set to LP position!
In order to switch to LOW PRESSURE FROM THE LANCE,
just UNTIGHTEN THE HANDLE (fig. 2).
Adjusting and going back to HIGH PRESSURE: TIGHTEN slightly!
26