RBM-20 Module - Quickstart Guide - v1.2 - Pearl Music Europe

CONNECTION DIAGRAM
WARNING: Use
only the included
Pearl power supply
with the RBM-20
module.
POWER
COMPUTER
DRUM KIT EXTERNAL MIDI MODULE MIDI KEYBOARD
• Connect your electronic drum set's triggers to the corresponding inputs on the module with the
appropriate 1/4" cables. Dual-zone pads or cymbals (e.g., a drum with head and rim triggers or a
cymbal that can produce bow and bell sounds) will require TRS cables to trigger both zones.
• Plug 1/4" TRS cables from the MAIN OUT or AUX OUT to an amplifier, mixer, or speaker system. (For
mono sound, you can connect only one output.)
• You can connect a set of 1/4" TRS headphones to the PHONES OUTPUT.
• You can connect another audio device to the AUX IN using standard RCA cables.
See the included assembly sheet for further instructions on setting up the E-Pro Live kit and connecting it
to the RBM-20 module.
NOTE: Out of the box, the RBM-20 module is write-protected, so you will be unable to save any changes
you make to the Kits, Instruments, Sequences, etc. To turn write protection off:
1. Press UTILITIES.
2. Press SYS (F4).
3. Press O/S (F3).
4. Press MEM (F4).
5. Press DEC- / INC+ or move the VALUE/TEMPO DIAL counterclockwise until the "WriteProt"
field says "OFF."
6. Press KIT SELECT to return to the main page.
IMPORTANT: THE RBM-20 MODULE MAY BE AFFECTED BY STATIC ELECTRICITY. IF THIS
OCCURS, SIMPLY TURN THE MODULE OFF AND WAIT AT LEAST A FEW SECONDS BEFORE
TURNING IT ON AGAIN.
2
volume
m1
m2
pitch x y z
- octave +
tap
accomp store
phrase latch
HOUSE AMP
CD PLAYER MONITORS
push
p r o g r a m s
r h y t h m s
s e t u p s
p a tt e r n s
c o n f i g
analog modeling synth