Руководство по эксплуатации Вытяжка ... - Schwab
Руководство по эксплуатации Вытяжка ... - Schwab
Руководство по эксплуатации Вытяжка ... - Schwab
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
8<br />
Information for Installation<br />
Your extraction hood can be used in circulating air or extraction mode.<br />
Circulating air mode<br />
In circulating air mode, the kitchen vapours are sucked in and, after puriication,<br />
discharged to the room air through the upper air discharge apertures. Puriication<br />
is carried out by the grease ilter and also by the carbon ilter (odour ilter with<br />
activated carbon; not in the scope of delivery).<br />
Advantage: Simple installation<br />
Disadvantage: With increasing contamination of the carbon ilter, the<br />
puriication and extraction effects recede. Depending on the use,<br />
the carbon ilter must be replaced approximately every three<br />
months.<br />
Extraction mode<br />
In extraction mode the kitchen vapours are sucked in, puriied by the grease ilter<br />
and discharged to the atmosphere through an exhaust air hose (not in the scope<br />
of delivery).<br />
Advantage: Carbon ilter not required, unpleasant odours are always very<br />
low.<br />
Disadvantage: Wall breakthrough (core drilling), 13 cm diameter with<br />
applicable hose connection required. Operation of open<br />
ireplaces in the same room is only possible to a limited extent<br />
(refer to Safety information, page 6).<br />
Important!<br />
If you should decide on the extraction mode and do not have a<br />
connection option for the hose, we recommend that you contact a<br />
specialist irm to make the wall breakthrough. If open ires are also<br />
operated in the same room, before installation seek advice from the<br />
local oficial heating inspector about the local regulations.<br />
If you are a tenant, approval of the owner is required.<br />
It is imperative to observe the safety information, pages 4-6. The<br />
connection for the exhaust air hose must be completed before<br />
the subsequently described installation.<br />
To bridge longer distances to the outside, an external motor can be installed in<br />
the exhaust duct. Consult a specialist electrical irm.<br />
Information