download - SpanSet GmbH & Co. KG

D
4. Insert the upper strap into the slot of the
cutter mechanism and the windlass. Hold the
tool and strap with your left hand and move
the tension lever forth and back until the
strap is tensioned.
Tensioner 75080 CT 40/50
Operation Instructions
1./2. Put strap around the package. Insert
strap into the buckle and tighten strap by
hand.
Adjustments
Before setting the tool into operation, make
sure that the tool has been adjusted to the
correct thickness of strapping in use.
Safety Instructions
This tool was designed and manufactured for
safe handling during the strapping operation.
D
GB
1. Before using the tool read the operating
instructions.
Fig. 1
Insert the strap and tension it
In tensioned condition turn set screw
(Fig. 1/1) up to the clamp frame
If the strap slips, the threaded pin must
loosened 1/4 - 1/2 rotation
GB
F
5. Depress the tension lever from the tensioner
completely until the strap is cut. Pivot
the tensioner away from the strap.
3. Take the tensioner by the right hand and
depress tension lever. Place strap under the
gripper so that it touches the housing with
the right hand edge. Release tension lever.
2. When operating the tool, wear eye-, faceand
hand-protection (Cutting protected gloves).
F
3. Do not put hand or other body parts
between strap and package.
4. When cutting the strap, hold the upper
portion and stay safely away.
Caution: The lower strap will snap forward.
5. Do not stand in line with the strap while it
is tensioned. The strap could break!
6. Original spare parts must be used exclusively.
Not using original spare parts will dissolve
the warranty and the limited liability.
Maintenance Instructions
Periodically lubricate all moving parts with
drops of light machine oil.
Daily clean clamp of any dirt or strap residue.