Wichtige Voraussetzungen für die erfolgreiche Montage - Closomat
Wichtige Voraussetzungen für die erfolgreiche Montage - Closomat
Wichtige Voraussetzungen für die erfolgreiche Montage - Closomat
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Controls:<br />
• If after pressing the left hinge the LED (A, Fig. 39), on the electronics does not light up, check the power<br />
supply to the unit.<br />
• The red LED „Boiler“ on the electronics (Fig. 31) shows a live water heating. It goes off after having reached<br />
the wanted temperature (after about 3-4 minutes). If the unit is on special customer’s need switched<br />
to „Boiler economy control“, the heating process only starts with loaded hinge (Fig. 32). If the LED „Boiler”<br />
does not light up or flash when heating process is expected, even if there is load on the left hinge, proceed<br />
as follows:<br />
- Press the „Reset-button“ of the safety temperature limiter (Fig. 33).<br />
If there is no success, check the power supply to the unit.<br />
• Checking the power supply to the unit: Switch off the main switch. Check whether plug is correctly inser<br />
ted into socket, the socket is under power, the fuse in the house as well as the earth leakage circuit braker<br />
is ok. Then switch on the main switch of the unit and try the function again. In case of doubt call the electrician.<br />
• If the douche jet always remains irregular (with air inclusions), check water supply. The cistern should be<br />
fed with at least 7 litres/minute. If this filling process stays weak even after having removed possible dirt in<br />
the pipes, e.g. with a flow pressure lower than 0,15 MPa (1,5 bar), one can remove the blue flow restrictor<br />
behind the big screw cap on the filling valve (Fig. 36) – when refitting the screw cap make sure that it is<br />
tightened only by hand (no tool!). Please note that this makes the filling process noisier!<br />
31