Guide d'utilisation Fr - 3 User's guide Gb - 19 Manual de ... - Num'Axes

Gb - 24indicator light on the collar will flash in green indicating that the collar is on.- Deactivate: Approach the area where the On/Off switch magnet is located in the remote controluntil coming in contact on red mark located on the collar, hold for 1 second (ref. Diagram 7 or 8).The indicator light on the collar will flash from green to red and then off: the collar is off.If you have several collars, renew the same procedure for each one.To increase the battery life of the collar, we recommend you to deactivate the unit if you are not usingit for a long period.Activate/deactivate areceiver collarwith a CANICOM 800 remotecontrolDiagram 7Approach until coming incontact those 2 areasduring 1 secondActivate/deactivate areceiver collarwith a CANICOM 1500remote controlDiagram 8Approach until coming incontact those 2 areasduring 1 secondCoding of the remote control and receiver collarThe coding of the remote control with the receiver collar enables the two units to work together. You canadd additional collars at any time.IMPORTANT : before beginning the coding (first use of the receiver or re-coding), make sure no otherperson is using his CANICOM 800/CANICOM 1500 or other products from the NUM'AXES range closeby. Your receiver could accidentally record the code of his remote control. If that occurs, re-code theremote control with the receiver collar.For CANICOM 800 :Collar A = black collar – Collar B = yellow collarFor CANICOM 1500 :Collar 1 = black collar – Collar 2 = yellow collar – Collar 3 = orange collar – Collar 4 = blue collarCoding procedure for the first use :Warning : If you have several collars, you have to code them one at a time.1. Activate the remote control: Press the On/Off red button located on the side of the remote controlfor 1 second.