Falmec Groupe aspirant ou filtrant Falmec GRUPPO INCASSO - notice
Falmec Groupe aspirant ou filtrant Falmec GRUPPO INCASSO - notice
Falmec Groupe aspirant ou filtrant Falmec GRUPPO INCASSO - notice
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
E<br />
F<br />
G<br />
- the brown wire must be used for the phase; the cable must not come into contact with hot<br />
parts (over 70°C).<br />
- fit a plug that is suitable for the load to the power cable, and connect it to a suitable power<br />
<strong>ou</strong>tlet.<br />
For appliances that come supplied with cable and plug please ensure they are plugged into a<br />
circuit suitable for this appliance.<br />
Please refer to a qualifed person. (See technical specifications in point B).<br />
The manufacturer declines all liability if the safety standards are not observed.<br />
RANGE HOOD WITH OUTSIDE DISCHARGE (exhaust)<br />
In this version, the fumes and steam from the kitchen are conveyed <strong>ou</strong>tside thr<strong>ou</strong>gh an exhaust<br />
duct. The exhaust conveyor that protrudes from the upper part of the range hood must be connected<br />
to a duct that carries the fumes and steam <strong>ou</strong>tside. In this version, the charcoal filters,<br />
if fitted, sh<strong>ou</strong>ld be removed; to do this, see the instructions in point F. There must be adequate<br />
ventilation of the room when the range hood is used at the same time as appliances burning<br />
gas or other fuels, according to the standard.<br />
Deviation for Germany:<br />
When the range hood and appliances supplied with energy other than electricity are simultane<strong>ou</strong>sly<br />
in operation, the negative pressure in the room must not exceed 4 Pa (4x10 E-5 bar).<br />
RECIRCULATING RANGE HOOD (with filter)<br />
In this model, the air passes thr<strong>ou</strong>gh the charcoal filters to be purified and is then recycled into<br />
the kitchen environment. See sect. H for assembly.<br />
OPERATION<br />
ELECTRONIC CONTROL PANEL<br />
Light pushbutton<br />
• ON: light on (the pushbutton is lit);<br />
• OFF: light off;<br />
Pushbutton -<br />
Press to reduce motor speed<br />
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and<br />
the timer LEDs).<br />
Pushbutton +<br />
Press to increase motor speed<br />
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and<br />
the timer LEDs).<br />
(In the 4-speed version the pushbutton + blinks. The f<strong>ou</strong>rth speed remains on for a set<br />
duration of time. After 15 minutes the motor returns to the third speed).<br />
Mode pushbutton<br />
Function: it turns hood motor on and off.<br />
The function “desired speed” enables to start the motor at the speed that was selected<br />
before the hood was last turned off.<br />
Timer pushbutton<br />
This function allows the automatic turning off of the hood after running for 15 minutes at<br />
the speed previ<strong>ou</strong>sly set (the pushbutton shows a flickering light).<br />
English<br />
23