Falmec Groupe aspirant ou filtrant Falmec GRUPPO INCASSO - notice

H
FILTERS REMOVING AND REPLACING’S INSTRUCTIONS
1. METAL FILTERS
To remove the anti-grease metal filters, just act on the specific handle. In the perimeter suction
hoods remove the steel panel as indicated in fig. H1 and then remove the metal filters.
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters as indicated
above. The two filters hooked on the right and left sides of the conveyor can now be easily
accessed. See figure for assembly/replacement.
Note: gruppo incasso NRS.
To assemble or replace the charcoal filters, see the instructions in the specific optional
charcoal filter kit for each model.
Gruppo incasso filter code kacl. 920.
To order new charcoal filters contact the distributor/retailer.
ONLY FOR ITALY: Download the filter order module from the website: www.falmec.com.
English
I
LIGHTING ASSEMBLY AND REPLACEMENT
1. SQUARE SPOTLIGHT
How to replace a square halogen light:
a) Check that the equipment is disconnected from the power supply.
b) Open the panel completely till 90° (see figure) pressing the PUSH button
c) Replace the lamp with a similar one (halogen, max 20 W, 12 Volt, G4 connection).
d) Close the panel. If the panel does not close correctly repeat the operation at point b.
2. LED
The gruppo incasso NRS is equipped with high efficiency, low consumption LED lighting with
extremely long duration under normal use conditions. LED spotlight replacement must be carried
out only by qualified technicians and using only original material.
25