KitchenAid 901 506 22 - 901 506 22 EN (857921516020) Istruzioni per l'Uso

61002001.book Page 14 Tuesday, March 25, 2008 4:46 PM
INSTALLATION INSTRUCTIONS
Recommendations
IMPORTANT: Unplug the oven before any cleaning and maintenance operations.
• Installation must be carried out by a qualified technician according to the manufacturer's instructions
and in compliance with the current local regulations
• After unpacking the oven, make sure it has not been damaged during transport and that the door closes
properly. In case of any doubts, contact the dealer or the nearest After-Sales Service.
Preparation of cabinet for fitting
• Cabinets in contact with the oven must be heat resistant (min. 90 °C).
• Carry out all cabinet cutting work before fitting the oven. Carefully remove any chips or sawdust that
could compromise oven operation.
• The bottom of the oven must not be accessible after installation.
• During installation make sure the sides of the oven do not touch the adjacent units.
• For correct appliance operation, the minimum opening required between the worktop and
the top of the oven must not be obstructed.
Electrical connection
Regulations require the appliance to be earthed.
• Electrical connection must be carried out by a qualified technician according to the manufacturer's
instructions and in compliance with the current local regulations.
• The installer is responsible for correct electrical connection and compliance with the safety regulations.
• The power cable must be long enough to make the electrical connection of the oven fitted in the
cabinet.
• The safety directives require a multi-pole switch with contact gap of at least 3 mm to be used during
installation.
• After installation, the electrical components must be inaccessible.
Connecting the oven to the power supply
• Make sure the voltage indicated on the dataplate is the same as the mains voltage.
The dataplate is on the front edge of the oven (visible when the door is open).
• If the oven is without a power cable, proceed as follows:
1. Remove the two fixing screws of the terminal block cover located in the bottom part of the oven's
back closing panel.
2. Remove the cover to access to the terminal block and insert the power cable (see table) through
the opening located on the bottom of the oven.
Power cable table
No. of wires
Type of cable
1N+ ~ H05 RR-F 3 X 1.5 mm²
2+ ~
H05 RR-F 3 X 1.5 mm²
(for Switzerland only)
3. Connect the cable to the terminal block, tighten the screws and secure it to the cable fastener.
4. Refit the cover, inserting the two tabs in the special slots, and fix it with the two screws.
14