600346027 DTW Dometic discharge pump manual - Waeco

Dometic Waste Discharge Pump Components
Note
When assembling pump, tighten fasteners to 20 (+/- 2) in .-lbs . or until snug . Overtightening
will cause holes to strip .
5 Specifications
5.1 Materials
Pump body: glass-filled polypropylene Duckbill valves: EPDM
Bellows: engineered PE/PP resin
5.2 Electrical Current Draw
Model Voltage (DC)
Power Draw
(amp average)
Fuse/
breaker
Flow (LPH/
GPH)
Wire
size
Weight
(kg/lbs.)
DTW12 12 6 10 1136 / 300 * 3 .2 / 7
DTW24 24 3 5 1136 / 300 * 3 .2 / 7
* 14-gauge or larger diameter wire is recommended . Specifications subject to change without notice .
5.3 Discharge / Suction Lifts (m/ft .)
Discharge 0 0 .6 / 2 1 .2 / 4 1 .8 / 6 2 .4 / 8 10
Suction 3 / 10 2 .4 / 8 1 .8 / 6 1 .2 / 4 0 .6 / 2 3
5.4 Dimensions (fig . 23
, page 2)
Ref. Dimension
A 349 mm / 13 .75 in .
B 197 mm / 7 .75 in .
C 95 mm / 3 .75 in .
5.5 Approvals
ISO8846; EMC Directive 2004/108/EC
6 Installation
6.1 New installation
Ref. Dimension
D 171 mm / 6 .75 in .
E 127 mm / 5 .0 in .
F 48 mm / 1 .875 in .
Note
Discharge pump is intended to be installed horizontally. The pump can be installed vertically with
the discharge side at top or installed on its side, but it may operate at reduced efficiency .
1. Select location for pump installation above holding tank. This prevents potential waste overflow during
system maintenance or repair . If available space prohibits installing pump above holding tank, create
5