SMG Issue 48.1

BATTERIES
PRECISION BATTERY MONITORS
Battery Monitors
792-BAM010700000 BMV-700 £163.20
792-BAM010700100 BMV-700H £672.00
792-BAM010702000 BMV-702 £202.80
792-BAM010702200 BMV-702 Black £202.80
792-BAM030712000 BMV-712 Smart £234.00
792-BAM030712200 BMV-712 Smart Black £234.00
● Displays Battery voltage, current,
power, ampere-hours consumed and
state of charge
● Time to go at the current rate of
discharge
● Prog. visual and audible alarm
● Prog. relay, to turn off non-critical
loads or run a generator
● BMV-700/702: 9 to 90 VDC range
● BMV-700HS: 70 to 350 VDC range
● BMV-702 has a 2nd input to
measure voltage (of a 2nd battery),
temperature or midpoint voltage
● BMV-712 : 6.5 to 70VDC range and
Bluetooth for remote monitoring on
smartphone or other devices
SmartShunt
792-SHU050150050 SmartShunt 500A/50mV £156.00
792-SHU050210050 SmartShunt 1000A/50mV £258.00
792-SHU050220050 SmartShunt 2000A/50mV £352.80
● All in one battery monitor, connecting
to a GX device or via Bluetooth to the
VictronConnect App on a smartphone
(or tablet)
● Conveniently read out all monitored
battery parameters, like state
of charge, time to go, historical
information and much more
● Connecting a GX device to the
SmartShunt requires a VE.Direct cable
● Ideal alternative for a BMV battery
monitor, when less wiring and clutter
is preferred
● Equipped with Bluetooth, a VE.Direct
port and a connection that can be
used for: monitoring a second battery,
midpoint monitoring or a temperature
sensor
BATTERIES
AGM Deep Cycle Battery
792-BAT406225084 6V / 240Ah £372.00
792-BAT212070084 12V / 8Ah £26.40
792-BAT212120086 12V / 14Ah £50.40
792-BAT212200084 12V / 22Ah £67.20
792-BAT412350084 12V / 38Ah £158.40
792-BAT412550084 12V / 60Ah £182.40
792-BAT412800084 12V / 90Ah £267.60
792-BAT412101084 12V / 110Ah £336.00
792-BAT412121084 12V / 130Ah £396.00
792-BAT412151084 12V / 165Ah £501.60
792-BAT412201084 12V / 220Ah £614.40
● Sealed AGM (Absorbent Glass Mat) batteries.
Suitable for short-time delivery of very high
currents (i.e. engine starting)
● Sealed GEL Deep Cycle batteries – Longer service
life & better cycle capacity
● VRLA or Valve Regulated Lead Acid batteries are
sealed, allowing gas to escape through the safety
valves only in case of overcharging or cell failure
● Exceptional leak resistance, and can be used in any
position. Maintenance free for life
● Exceptional discharge recovery, even after deep or
prolonged discharge
● Can be stored up to a year without recharging if
kept under cool conditions because of the use of
lead calcium grids & high purity materials
● Self-discharge rate less than 2% per month at
20°C
GEL Deep Cycle Battery
792-BAT412550104 12V / 60Ah £208.80
792-BAT412600104 12V / 66Ah £261.60
792-BAT412800104 12V / 90Ah £276.00
792-BAT412101104 12V / 110Ah £342.00
792-BAT412121104 12V / 130Ah £400.80
792-BAT412151104 12V / 165Ah £516.00
792-BAT412201104 12V / 220Ah £632.40
LiFePO4 Battery Smart
792-BAT512050610 12.8V / 50Ah £699.60
792-BAT512110610 12.8V / 100Ah £1,148.40
792-BAT512116610 12.8V / 160Ah £1,648.80
792-BAT512120610 12.8V / 200Ah £2,268.00
● LiFePO4 (Lithium Iron Phosphate) Lithium
Battery Smart with integrated cell balancing
● Can be connected in series, parallel and series/
parallel (maximum number of batteries in one
system is 20 - maximum energy storage of 84 kWh
in a 12V system)
● Long service life, superior reliability and excellent
efficiency when compared to lead-acid batteries
● Bluetooth app available to monitor cell voltage and
temperature
BATTERY ISOLATORS
Diode Isolators
FET Isolators
792-ARG080202000 Argodiode 80-2SC - 2 Batteries 80a £46.80
792-ARG080201000 Argodiode 80-2AC - 2 Batteries 80a £60.00
792-ARG100301000R Argodiode 100-3AC - 3 Batteries 100a £81.60
792-ARG120201020R Argodiode 120-2AC - 2 Batteries 120a £91.20
● Allows simultaneous charging of two or more batteries from
one alternator, without connecting the batteries together.
Discharging the accessory battery for example will not
result in also discharging the starter battery
● Alternator energize input (not applicable to 2SC)
- Some alternators need DC voltage on the B+ output to
start charging. Obviously, DC will be present when the
alternator is directly connected to a battery. Inserting
a Diode or FET splitter will however prevent any return
voltage/current from the batteries to the B+, and the
alternator will not start
- The new ‘AC’ diode isolators feature a special current
limited energize input that will power the B+ when the
engine run/stop switch is closed
792-ARG100201020 Argofet 100-2 - 2 Batteries 100A £120.00
792-ARG100301020 Argofet 100-3 - 3 Batteries 100A £138.00
792-ARG200201020 Argofet 200-2 - 2 Batteries 200A £142.80
792-ARG200301020 Argofet 200-3 - 3 Batteries 200A £168.00
● Allows simultaneous charging of two or more
batteries from one alternator (or a single output
battery charger), without connecting the batteries
together. Discharging the accessory battery for
example will not result in also discharging the
starter battery
● In contrast with Diode Battery Isolators, FET
Isolators have virtually no voltage loss. Voltage
drop is less than 0,02 Volt at low current and
averages 0,1 Volt at higher currents
VICTRON ENERGY
All prices SRP inc VAT at 04/2023. For trade prices and stock availability visit www.smgeurope.com
137