SMG Issue 48.1

ELECTRICAL MONITORING AND CONTROL
ACM100 Alternating Current Monitor
Monitors AC power sources and outputs information onto the NMEA 2000 network.
468-ACM100-01 Alternating Current (AC) Monitor £400.46
468-M000630 100 Amp AC Transducer with Cable £74.16
468-M000612 400 Amp AC Transducer with Cable £422.22
● Single phase, split phase or 3-phase AC Sources
● Monitoring of busses carrying AC power and transmitting:
- Voltage
- Frequency
● Monitoring AC Power sources such as utilities and generators and transmitting:
- Voltage
- Current
- Frequency
- Real Power
- Reactive Power
- Apparent Power
- Power Factor
- Total Energy Imported
- Total Energy Exported
M000612
M000630
DCM100 Direct Current Monitor
468-DCM100-01 Direct Current Monitor £489.46
468-FC01 DCM100 Battery Harness with Fuse £42.00
468-LEMHTA200-S 200 Amp Current Transducer with Cable £97.90
468-LEMHTA400-S 400 Amp Current Transducer with Cable £166.12
468-LEMHTA600-S 600 Amp Current Transducer with Cable £201.72
468-TR3K DCM100 Ring/Under Bolt Temperature Probe £32.63
Measures the voltage and current of any direct current (DC) power source or loads,
including batteries, alternators, solar panels, wind generators, inverters, windlasses,
DC refrigerators, or any DC branch circuit. Hall effect current sensor just simply slips
over the wire.
● Information monitored:
- Battery Voltage
- Battery Current
- Ripple Voltage
- Battery Case Temperature
- State of Charge
- Time Remaining
- Charge Efficiency Factor
FC01 LEMHTAx00-S TR3K
DCR100 Direct Current Relays
468-DCR100-01 Direct Current Relays £352.01
Contains 6 Direct Current (DC) relays, each capable of switching up to 10 amps.
Connect directly to an NMEA 2000 network and turn on and off the relays from any
device onboard. Can handle resistive DC loads like lights, or inductive DC loads like
pumps and motors, and can also be used to switch AC circuits using external relays.
● Six relays for On/Off control over NMEA 2000® Network
● Each relay capable of carrying up to 10 amps
● Individual relay electrical current monitoring
● Automatic relay over current shutdown (shuts down at ≈ 12 amps)
● Automatic relay thermal shutdown (over temperature protection)
● Relays switchable using Maretron DSM Series, N2KView®, or N2KView® Mobile
● DCR100 can be configured as an annunciator to activate a buzzer, horn, or strobe
light as a result of an alert
● Individual DCR100 channels can be locked into On/Off state
● Individual DCR100 channels can be configured with default power up state (e.g.,
On/Off/Previous)
RIM100 Run Indicator Module
468-RIM100-01 Run Indicator Module £296.64
468-WIF-RK30880-E Water in Fuel Detector £248.18
Monitors both AC and DC electrical circuits whether or not the electrical circuit is
energized and running. Can also monitor manually switched loads (running lights,
anchor lights, or deck lights) or auto switched loads (bilge pumps, engine exhaust/
intake fans, and transfer pumps).
● Monitors and reports the running statuses of six independently connected devices
● Works with both AC and DC loads
● Works with both automatically and manually switched loads
● Includes built in timers and counters
● Can indicate the status of a wide variety of loads
- Bilge Pumps
- Winches
- Running Lights
- Transfer Pumps
- Exhaust/Intake Fans
- Water in Fuel notification
94 MARETRON
SIM100 Switch Indicator Module
468-SIM100-01 Switch Indicator Module £341.14
468-SH-003 Smoke/Heat Detector Hi Temp Kit £249.18
468-BHW100 Bilge High Water Detector £60.31
468-CO-CO1224T Carbon Monoxide (CO) Detector (Surface Mount) £192.82
468-IS216 Motion Detector £40.54
468-VS-07.0HG Vacuum Switch (7” Hg or 24kPa) £86.03
468-MS-1035 Magnetic Switch Rectangular (Indoor) £7.61
468-MS-1085-N Magnetic Switch Rectangular (Outdoor) £16.72
468-MS-1075 Magnetic Switch Recessed (Indoor/Outdoor) £3.76
Continually monitors up to six switch closure devices,
such as motion, vibration, glass break, door, port hole,
valve closed/open, high water, bilge heat, smoke, carbon
monoxide and broadcasts information over the NMEA
2000 network.
The crew can be alerted to the switch state, and highlight
potential conditions or problems for investigation.
C0-CO1224T MS-1035 SH-003 BHW100
www.smgeurope.com 01752 241010 sales@smgeurope.com