SMG Issue 48.1

BOAT SWITCH
Boat Switch
Ready To Go Digital Switching Solution
230-0100273500 Boat Switch £949.99
This all in one digital switching solution is ready to go out of the box with no custom
design or configuration loading required. It lets you operate up to 20 circuits right
from your compatible GPSMAP® or ECHOMAP chartplotter instead of using physical
buttons or switches. It offers four different switch types, including on/off for bilge
pumps and nav lights, press and hold dimmers for cabin lights, momentary outputs for
horns and timer to circulate your livewell pump. Plus, it provides built in tank sender
detection and calibration for as many as four tanks including fuel, fresh water, gr e y
water, black water and livewell. It installs without special tools and allows you to easily
add and name switches on your chartplotter display.
Boat Switch
Harness X1 & X2
● ALL IN ONE - All in one system replaces existing fuse box and switches on boats for
easier control and operation of onboard functions
● CONTROL AND PROTECTION - Offers control and protection of up to 20 circuits
from your compatible GPSMAP ® or ECHOMAP chartplotter rather than a physical
button or switch
● MANAGE MULTIPLE OUTPUT TYPES - Manage four different output types, including
on/off toggle, dimming, momentary on and built in timer for livewell pumps and
bilge pumps
● CUSTOMIS ABLE - Position, name and remove switches on the easy to use
chartplotter interface
● TANK SENDER DETECTION - Built in tank sender detection and calibration for as
many as four tanks, including fuel, fresh water, gray water, black water and livewell
● EASILY RETROFIT - Easily retrofit into existing boats without special tools, training
or configuration by using included 18” flying leads and colo u r coded channel wires
● Unit only Dimensions (W xHx D) 230x106x38 mm
● Enclosure water rating : IP65
● Communication: CAN-bus NMEA 2000® network, LEN-0
● Output - High side : 13 ch 10A, 7 ch 5A
● Digital input:
- Ground contact switch input : 15
- Bilge pump monitor : 2
● Analog input Volt : 3 @ 0-16 V +/- 1%
● Power supply:
- Maximum curren t 50A
- Supply voltage (12V) : 9-16 VDC
● Includes : Garmin Boat Switch, Garmin Boat Switch Unit Harness X1, Garmin Boat
Switch Unit Harness X2, Installation Instructions
OnDeck Hub
230-0100213400 OnDeck Hub £819.99
Track, monitor and control up to 5 switches on your boat with the OnDeck system, a
fully integrated remote connectivity solution.
● TRACK AND MONITOR - Know where your vessel is at all times using the OnDeck
GPS and the app's map interface
● CONFIGURE - Use the app to set up alarms to notify you and others of changes to
your boat
● CONTROL - Access up to 5 of your boat's relay switches through the app to turn
selected systems on or off remotely
● VIEW HISTORICAL DATA - Store up to 30 days of collected data and on-board
sensor readings
Note : An active subscription plan is required. Both OnDeck Hub and user’s device
must have connectivity to a 3G/4G network.
TD50 5" Digital Display
230-0100213910 £589.99
The TD50 is a 5” touchscreen display intended for use as a secondary digital switching
unit. EmpirBus allows you to control onboard electrical and electronic systems like
lighting, air-conditioning, navigation lights, wipers, horns, entertainment systems,
security systems and much more.
● Waterproof rating: IPX7
● Configurable backlight and language capabilities
● Can be updated by MFD or ethernet Garmin card reader
All prices SRP inc VAT at 04/2023. For trade prices and stock availability visit www.smgeurope.com
37 GARMIN