02.03.2013 Views

Tellabs 7345 Ethernet Aggregation Switch

Tellabs 7345 Ethernet Aggregation Switch

Tellabs 7345 Ethernet Aggregation Switch

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

2 TELLABS <strong>7345</strong> ETHERNET AGGREGATION SWITCH<br />

Specifications<br />

<strong>Ethernet</strong><br />

n 24/48 SFP-based 10/100/1000 Mbps ports<br />

n Up to four 10GbE XFP ports<br />

n CWDM XFP Support<br />

n 802.1D — MAC Bridging<br />

– STP/RSTP<br />

n 802.1Q — VLAN Bridging<br />

– MSTP<br />

n 802.1ad 2 — Provider Bridging<br />

– VLAN <strong>Switch</strong>ing/ stacking<br />

– Q-in-Q support<br />

n G.8031 — <strong>Ethernet</strong> Linear Protection <strong>Switch</strong>ing<br />

n G.8032 1 — <strong>Ethernet</strong> Ring Protection <strong>Switch</strong>ing<br />

n Dedicated EP-Line, EP-LAN, and EP-Access <strong>Ethernet</strong> services<br />

n Multiplexed EVP-Line, EVP-LAN, and EVP-Access <strong>Ethernet</strong><br />

services<br />

n 802.3ad 3 — Link <strong>Aggregation</strong> Control Protocol (LACP)<br />

n 802.3ah 3 — Link OAM<br />

n 802.1ag 2 — <strong>Ethernet</strong> Connectivity OAM<br />

n Y.1731 — Service Layer OAM<br />

n Jumbo frames<br />

n 40Gb/s switching capacity<br />

n 32K MAC addresses<br />

n 4K VLANs<br />

n Port Mirroring<br />

n VLAN Mirroring<br />

n Resilient VLAN Tunneling (RVT)<br />

Multicast Support<br />

n 1K Multicast groups<br />

n IGMP Snooping<br />

Synchronization<br />

n G.8261-2006, G.8262 - Synchronous <strong>Ethernet</strong> on all ports<br />

n G.8264 - Sync Status Messaging (SSM)<br />

n Stratum-3 timing holdover<br />

n E1/T1 BITS timing reference input and output<br />

1. Supported by upcoming software release already under development.<br />

Fault Management<br />

n Supports a variety of link fault detection and fault propagation<br />

features<br />

– Link fault notifications<br />

– Link/VLAN RDI (T-RDI and 802.1ag RDI)<br />

– Link fault propagation over port level service via automatic laser<br />

shut off<br />

n 802.3ah Link OAM<br />

– Link loopback<br />

– Unidirectional link fault detection<br />

– Threshold-based monitoring and notification<br />

n 802.1ag end-to-end Service OAM and CFM<br />

– Supports eight levels of maintenance domains and Maintenance<br />

End Points (MEP)<br />

– 64 Maintenance Associations<br />

– Connectivity Check Messages (CCM)<br />

– Remote Defect Indication (RDI)<br />

– Link Trace<br />

– Diagnostic loopback (Layer 2 ping)<br />

n Y.1731 Alarm Indication Signal (AIS)<br />

n Sub 50ms Failover Protection <strong>Switch</strong>ing<br />

Traffic Management<br />

n Layer 2 and Layer 3 traffic classification<br />

n Eight Class of Service (CoS) queues per port<br />

n Traffic prioritization based on:<br />

– 802.1p QoS<br />

– Type of Service (ToS)<br />

– DSCP<br />

– Layer 2 Control Protocol (L2CP)<br />

n QoS metering per Port, VLAN, or CoS flow<br />

n Flexible scheduling – strict priority and deficit-weighted round<br />

robin<br />

n Ingress policing and egress rate shaping<br />

n IGMP Snooping<br />

2. 802.1ag and 802.1ad are 802.1Q amendments prior 2011 and were included in 802.1Q-2011.<br />

n Single Rate Three Color Marking (srTCM) — RFC 2697<br />

n Two Rate Three Color Marking (trTCM) — RFC 2698<br />

n MEF policing, color aware and unaware, with coupling flag<br />

Performance Test & Monitoring<br />

n Y.1731 Performance Monitoring<br />

– Frame delay<br />

– Frame delay variation (jitter)<br />

– Frame loss<br />

3. 802.3ad and 802.3ah are 802.3 amendments prior 2008, 802.3ah was included in 802.3-2008, 802.3ad for LAG became 802.1AX.<br />

See tellabs.com for more information about <strong>Tellabs</strong> Solutions

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!