emh2 Electric Mobile Home 2 Wallbox - ABL Sursum

TRoUBLESHooTING
Wallbox
8 Troubleshooting
If an automatic power failure occurs, open the front cover shown
below and use the lever to reset the tripped circuit breaker.
If this is unsuccessful and the residual current circuit breaker trips
again, there is probably a fault that can only be eliminated by
trained and qualified personnel.
Please note that the warranty will not apply if unauthorized repairs
are carried out. ABL­SURSUM shall not be liable for any consequential
damages or losses.
Fault Possible cause Remedy
Charging cycle does not start even
though the LED is flashing
Charging cycle does not start even
though the LED is not illuminated
No LED display · LED defective
LED
and
LED
flash alternately
18
Charging cable not inserted correctly
at the vehicle or at the charging box
· Residual current circuit breaker of
the charging box has tripped
· Upstream fuse in the house fuse box
has blown
· LED wire faulty
Check secure connection of the plug at the
vehicle and, if necessary, at the charging box
(disconnect, reconnect the plug)
· Disconnect the plug at the vehicle, open
the cover of the charging box, reset the
residual circuit breaker; reconnect the plug
· Check the fuses of the upstream power
supply (usually in the house fuse box)
· Contact the Customer Service Department
· Contact the Customer Service Department
Fault Disconnect the plug from the vehicle and
repeat charging. If the problem occurs again,
contact the Customer Service Department