UVA 97033 UVC 97034 - Henkel

18
4 Installation
• Remove the knurled screw on the side
of the lamp-module.
• Unplug the lamp-module connectors
and swivel the module backwards and
then move upwards.
• Remove the transport safety cushions
from the new lamp module, see
section 4.4
• Insert the lamp module by setting the
alignment cut outs into the support pins.
• Gently push forward until the module is
locked in the vertical position.
• Install the knurled screw on the side of
the lamp module.
• Connect the red wire (A) at the bottom
and the black wire (B) at the top of the
lamp-module.
Never leave the red wire disconnected
when the ignition button is pressed.
The power supply will be destroyed (if
you are repackaging for shipment with
foam cushions, only leave the top
black wire disconnected).
• When replacing the top cover, make
sure the control cam for the safety
switch is pointing to the right hand side
otherwise the unit will not operate.
• Connect the earth cable.
The lamp contains mercury. Do not discard with regular trash. Disposal as hazardous
waste is required.
B
A