Installation Instructions / Montageanleitung - Hansgrohe

Assembly
Attention!
The fitting must be installed, flushed and tested after
the valid norms!
1. Flush through the supply pipes.
2. Fasten the mixer with the washers.
Large differences in pressure between the hot and
cold water supply should be balanced.
Adjustment
Correction is necessary if the temperature measured
at the take off point differs from the temperature set
on the scale. To adjust please see page 7.
Operation
The mixer is operated by turning the handle on the
left hand side.
The temperature is selected by turning the graduated
handle on the right side.
The flow of the bath mixer can be changed from
tub to shower function by simply pulling the diverter
knob located at the top of the outlet.When the water
is shut off the flow returns automatically to the bath
function.
To garantee a smooth running of the thermoelent, it
is necessary from time to time to turn the thermostat
from total hot to total cold.
English
Attention!
The mixer is equipped with non return valves.
The non return valves must be checked regularly according
to DIN EN 1717 in accordance with national
or regional regulations (at least once a year).
Technical Data
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure: 1,6 MPa
Hot water temperature: max. 80° C
Recommended hot water temp.: 65° C
Rate of flow tub spout: 58 l/min by 0,3 MPa
Rate of flow shower outlet: 18 l/min by 0,3 MPa
antipollution function
(1 MPa = 10 bars = 147 PSI)
Spare parts (see page 2)
1 thermoelement 96633000
2 shut off unit 92929000
3 handel 98870000
4 diverter fixing device 97211000
5 aerator cpl. 97163000
6 diverter knob 96488000
7 selector cpl. 97164000
8 connecting thread cpl. 97210000
9 filter packing 96922000