MB200 MR200 - Acumo
MB200 MR200 - Acumo
MB200 MR200 - Acumo
Erfolgreiche ePaper selbst erstellen
Machen Sie aus Ihren PDF Publikationen ein blätterbares Flipbook mit unserer einzigartigen Google optimierten e-Paper Software.
8.<br />
9.<br />
Push parts 2 and 7 together and screw part 11<br />
using appropriate tool.<br />
Push part 8 into part 9 and slide both parts<br />
into part 7.<br />
10. Screw parts 10 and 7 together.<br />
11. Push part 1 into part 2.<br />
socket<br />
screening<br />
6. Trouble shooting<br />
Below are some typical errors which may occur during<br />
installation and operation:<br />
• Magnetic strip incorrectly mounted (active surface<br />
must be mounted towards the sensor) (see<br />
chapter 3.1).<br />
• Use of foreign protective strip. Must always be<br />
non-magnetic.<br />
• Sensor not or incorrectly connected (pin connection,<br />
see chapter 4.2).<br />
• Tolerance for the gap between magnetic sensor and<br />
magnetic strip not observed over the total travel<br />
distance. Sensor touches strip (see fig. 6+7).<br />
• Cable squeezed / interrupted / cut by sharp<br />
edges.<br />
• Sensor's active side not mounted towards the<br />
magnetic strip (see fig. 6+7).<br />
• Sensor has not been aligned according to fig.<br />
6+7.<br />
pin<br />
Fig. 9: Mounting connection type E6<br />
E8: Connection with 9 pole D-SUB plug pin and<br />
socket contact.<br />
viewing side = plug-in side<br />
Signal<br />
not<br />
inverted<br />
inverted<br />
inverted with<br />
reference signal<br />
E6 E8 E6 E8 E6 E8<br />
A PIN 3 PIN 3 PIN 1 PIN 1 PIN 1 PIN 1<br />
B 4 4 2 2 2 2<br />
I - - - - - - - - - - - - 3 3<br />
+UB 2 2 4 4 4 4<br />
GND 1 1 5 5 5 5<br />
A/ - - - - - - 6 6 6 6<br />
B/ - - - - - - 7 7 7 7<br />
I/ - - - - - - - - - - - - 8 8<br />
- - - 5-7 5-9 3 3, 8, 9 9<br />
5. Maintenance<br />
We recommend cleaning the magnetic strip’s surface<br />
from time to time with a soft rag. This avoids dirt<br />
(dust, chips, humidity ...) sticking to the strip.<br />
SIKO GmbH<br />
Werk / Factory:<br />
Weihermattenweg 2<br />
79256 Buchenbach-Unteribental<br />
Postanschrift / Postal address:<br />
Postfach 1106<br />
79195 Kirchzarten<br />
Telefon/Phone +49 7661 394-0<br />
Telefax/Fax +49 7661 394-388<br />
E-Mail<br />
info@siko.de<br />
Internet www.siko.de<br />
Service support@siko.de<br />
8 MSK210+<strong>MB200</strong>+<strong>MR200</strong> Datum 09.11.2009 Art.Nr. 81417 Änd. Stand 326/09