gr-3755 Anleitung DE-EN-FR

about this, it is best to take out a special insurance covering the operation of RC models.These safety notes must be kept in a safe place. If you ever dispose of the module, be sureto pass them on to the new owner.The following points are important, and must be observed at all times:• The switching module is not suitable for use by children below fourteen years of age.• Before you run the model, it is important to check that the radio control system isoperating correctly, and that all plug-in connectors are firmly seated.• Check that your channel is not already in use. Never switch your system on if you are notcertain that your channel is free.• Bear in mind that other radio equipment and public service transmitters are potentialsources of powerful interference. As far as possible, ensure that no apparatus of this kindis in use while you operate your model.• Never exceed the recommended operating voltage. Higher voltages may damage or ruinyour module and model.• Do not subject the switching module to severe humidity, heat, cold or soiling.• Take particular care to keep your model watertight. Open the model after each run, andallow it to dry out naturally.Care and maintenance• If water gets inside the boat, open the hatch to allow it to escape. If water shouldpenetrate the case of the switching module, dry it out thoroughly before sending it to yournearest GRAUPNER Service Centre for checking.• An effective preventative measure to avoid damp problems is to spray the module usingWET.PROTECT, Order No. 968.50.Safety notes• Read right through these operating instructions before you use the module for the firsttime, and keep them in a safe place in case you need to consult them in future.• The switching module’s integrated circuits are sensitive to electro-static charge. Takegreat care not to touch these components unless you have “discharged” yourselfbeforehand (e.g. by grasping a central heating radiator or other earthed device).• The switching module must only be used in conjunction with a power supply withinthe voltage range stated in the Specification.• The unit must be disconnected from the power supply before any electricalconnections are made.• This switching module is not suitable for use by children under fourteen years of age.Operating InstructionsFunctionsThe purpose of the switching module is to switch high-current consumer units (e.g.motors, lamps, pumps, etc.) drawing a maximum current of 10 A. It can also be usedin circuits where, for example, the current-handling capacity of an existing switchmodule is not sufficient for the consumer unit you wish to control.The switching module is generally controlled using the outputs of a Soundswitch 1 orthe outputs of a Light module. The two inputs of the module are negative-switching,i.e. the switch module connected to it must also have negative-switching outputs.The switching module features two modes of operation: “switching mode” and “motormode”. In Switching mode it is possible to switch two consumer units on and offGRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANYNo liability for printing errors. Technical modifications reserved. #0061023 11/2009