Untitled - ER Decor

ER-“O”-WASSER ER-“O”-WATER
ER "O"-Water is a one component liquid plastic casting
PVC, available in three basic colours. Create water
at an incredibly low price !
Ideal for static and moving water, for mountain rapids,
rivers, canals, lakes, pools, ponds, drains etc.
This product is known for its simplicity of use: just
pour it and let it harden. By exposing it to air, the
liquid starts to dry out and harden. "O"-Water becomes
darker the thicker it is applied.
This product is specially developed to create large
water surfaces where an impression of some depth is
desired. Different water colours can be obtained by
mixing of the clear "O"-Water with some of the blue
and green "O"-Water. To obtain the best colour result
it is best to test it using small quantities.
By using "O"-Water combined with ER-Aquafibres
art.no. 7525 (725.145) it is very easy to create realistic
waterfalls.
"O"-Water as a membrane for large
water surfaces
This product is specially developed to create an impression
of depth without using too much water material
thus keeping the costs low. The formula is especially
good for larger rivers, lakes, harbours or seas.
To use it is simple: pour the "O"-Water onto a non
porous surface: a flat piece of glass (still water),
frosted glass (for wave effects) or similar plastic or
formica sheets. The "O"-Water will flow out and
harden. Then you peel it off the non-porous surface
and put it in the desired place.
The sheet can easily be pierced which allows reeds or
branches to stick from the bottom up to the surface.
Coverage with the contents of a 120ml. bottle is
about 8 cm⇢.
"O"-Water directly on the landscape
as flowing water
This is the method to create mountain streams, small
rivers and waterfalls.
For this method you must pay attention to limit the
layer thickness to a maximum 2 to 3 mm. Once the
first layer has dried, you can of course pour a second
layer to build up the layer thickness.
Before pouring the water you must create the river
bed using small stones, rocks, sand and vegetation.
By using "O" Water combined with ER-Aquafibres
56
art.no. 7525 (725.145), creating waterfalls is very easy,
and by pouring the "O"-Water drop by drop and allowing
it to harden you can form stalactites and spray
formations.
"O"-Water directly on the landscape
as sealant for real water
After placing vegetation, rocks, sand, etc. you can
pour a thin layer of "O"-Water over the bottom of the
water area. This layer, after hardening, will from a
water tight and colourful under-surface for your river.
Once the product is dry it forms a watertight seal thus
creating a perfect bed for real flowing water.
"O"-Water as glue
The product, if used in a very thin layer, is ideal to fix
people, cars, etc. to the layout.