Pedal Boat Owner's Manual - Future Beach

Assembly Instructions WB Series Only
A1
A2
A3
A4
Carefully unwrap your Future
Beach ® pedal boat and inspect for
any damage that may have occurred
in shipping. Report any damage immediately
to the carrier in writing.
Release and unwrap parts tied to
hull.
To access the paddle hub turn the boat
on its side. The paddle hub comes already
installed with one paddle blade
to show the right rotating direction
of the blades. Locate an open slot
on the paddle hub. Align the base
of each blade and push it firmly into
slot. Ensure the blade snaps into the
paddle hub. Repeat for the remaining
blades ensuring that all blades
are installed in the same direction as
the preinstalled blade.
If you purchased a boat with a
cooler lid proceed to Step 4. Otherwise
insert commercial tiller (Aluminum
tiller arm) into the boat and
proceed to Step A8.
Using a rubber hammer, install the
connected front and rear steering
arms onto the rudder shaft and
rudder c-clip.
9