Service Manual - Burner Components - Danfoss

Oil pumps
Oil pumps – Danfoss RS
Danfoss oil pumps - older series ➨ Replacement Danfoss types
Type Code no.
1/2pipe
RS 60 070-3312 2 ➨ RSA 60 070-3362
RS 60 070L3312 2 ➨ RSA 60 070L3362
Oil pumps – Danfoss RSL
➨ Type Code no. Comments/accessories
Danfoss oil pumps - older series ➨ Replacement Danfoss types
Type Code no.
1/2pipe
➨ Type Code no. Comments/accessories
RSL 028 070-4330 1 ➨ BFP 21 R3 071N01571) RSL 028 070L4330 1 ➨ BFP 21 L3 071N01566) + cable, L = 710 mm: 071G0204
RSL 028 070-4332 2 ➨ BFP 21 R3 1) 7)
071N0157
RSL 028 070L4332 2 ➨ BFP 21 L3 6) 7)
071N0156
RSL 028 070-4340 1 ➨ BFP 21 R3 071N01571) RSL 028 070L4340 1 ➨ BFP 21 L3 071N01566) + cable, L = 710 mm: 071G0204
RSL 028 070-4342 2 ➨ BFP 21 R3 071N01571) 7) + bush ∅54: 071B0011
RSL 028 070L4342 2 ➨ BFP 21 L3 6) 7)
071N0156
RSL 050 070-3130 1 ➨ BFP 21 R5 071N01732) RSL 050 070L3130 1 ➨ BFP 21 L5 071N0172
+ cable, L = 710 mm: 071G0204
2)
RSL 050 070-3132 2 ➨ BFP 21 R5 071N01732) RSL 050 070L3132 2 ➨ BFP 21 L5 071N01722) RSL 050 070-3140 1 ➨ BFP 21 R5 071N01732) + cable, L = 710 mm: 071G0204
RSL 050 070L3140 1 ➨ RFP 21 L5 071N01722) + bush ∅54: 071B0011
1) The solenoid coil must be connected in parallel with the burner motor.
2) Important: These pumps are delivered for two-pipe operation. If the pumps are mounted on a one-pipe system, the changeover screw must be removed
(fig. page 6) and the return port must be stopped with a metal plug.
6) If the pump is wanted delivered incl. cable, bush and flange, please order 071N0132.
7) This pump is for one-pipe operation. On pumps for two-pipe operation the changeover screw must be fitted.
8