EuroLite Slate Installation Guide Revised Sept 2011 - Euroshield
EuroLite Slate Installation Guide Revised Sept 2011 - Euroshield
EuroLite Slate Installation Guide Revised Sept 2011 - Euroshield
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
As with the starter strip panels, installation must start at the left side of the roof. If working left to<br />
right out of a valley, place the top left portion of the panel in the valley such that the diagonal cut<br />
down, 4 inches out from the centerline of the valley, from left to right cuts through the entire<br />
panel. The overlap on each piece is fitted into the overlap of the preceding one. At the ends of the<br />
courses trim panels (using a power saw or knife), to be flush with the edge.<br />
Panels are installed using eight (8) 1 ¾” galvanized roofing nails (see illustration above and in<br />
“Fastening” section). This will ensure that there are ten (16) attachment points in each panel as the<br />
fasteners will go through the top portion of the panel below.<br />
ROOF JACKS<br />
Roof Jacks may be fitted and removed in the same manner as with asphalt shingles.<br />
<strong>Euroshield</strong> <strong>Installation</strong> <strong>Guide</strong> – EUROLITE SLATE <strong>Sept</strong>ember <strong>2011</strong><br />
Page22