Recommended installation procedures for EuroLite ... - Euroshield

Working from left to right, install the first EuroLite Shake panel such that the raised nibs on the
back of the panel touch the top of the eave starter strip below. The first full panel will extend ¾”
past the gable edge. Nail the first panel in place using 7 – 1 ¾” galvanized roofing nails where
indicated in the diagram (see Fastening section). The locking tab in the upper left corner of the
panel will be trimmed off at this point with a knife so the edge is smooth. The next panel will then
be lowered down until the alignment nibs on the back of the panel touch the top portion of the
eave starter in the same manner as the first panel and then slide the panel gently to the left so that
the tab fits into the receiver of the first panel. Press the butt edge of each panel section down so
that the adhesive strip makes contact with the panel below. Continue in this manner until the right
gable is reached and trim the last panel such that you have ¾” overhang on the gable end and are
flush with the edge of the eave starter overhang.
Euroshield® Installation Guide – EUROLITE SHAKE March 2012
Page20