Recommended installation procedures for EuroLite ... - Euroshield

More documents

Recommendations

Info

Each cap is fastened using four (4) 3” galvanized deck screws, two (2) on either side. The last cap must be “face fastened”, and exposed fastener heads must be sealed using G.E.M. sealant (or equivalent co-polymer sealant). Euroshield® Installation Guide – EUROLITE SHAKE March 2012 Page24
HIP CAP The hip caps are the same piece as the ridge caps and are installed in the same manner as ridge caps. Beginning at the eave, overhang the first cap by ¾” and fasten where indicated in the diagram on page 24. Place the next cap above the first and lower until the nibs on the underside of the cap touch the top portion of the cap below. The correct exposure of 7 5/8” in now set automatically. Continue working your way up the hip in similar fashion, fastening each cap with four (4) 3” galvanized deck screws, two (2) on each side such that the overlapping cap covers the fastener. Note that the caps are notched at the butt edge to allow for variable pitch applications And the notch can be cut (widened) further to allow for steep pitch applications. HIP DETAIL AT RIDGE Euroshield® Installation Guide – EUROLITE SHAKE March 2012 Page25
Page 1 and 2: Recommended installation procedures
Page 3 and 4: INTRODUCTION Corporate profile Calg
Page 5 and 6: Ridge Cap 16 caps per bundle 36 bun
Page 7 and 8: To reduce ice dam formation and hel
Page 9 and 10: the National Building Code (or corr
Page 11 and 12: Each Eave/Rake/Valley Starter Strip
Page 13 and 14: LOADING Always load EuroShield® pr
Page 15 and 16: VENT PIPE INSTALLATION (Top and sid
Page 17 and 18: CHIMNEY INSTALLATION Euroshield® I
Page 19 and 20: Moving up the rake edge, install th
Page 21 and 22: Do not nail the face of the panel a
Page 23: Walls, chimneys, plumbing vents, at
Page 27 and 28: Panels have an SBR adhesive strip a

Recommended installation procedures for EuroLite ... - Euroshield

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?