WHITE SUPERLOCK OWNERS WORKBOOK 2000 ATS - Singer

More documents

Recommendations

Info

HELPFUL HINTS - CHANGING THREAD The following steps may be helpful when changing your threads. .Cut off threads that are on your Superlock near the spools and replace the spools with new ones. Tie new thread on to old threads with overhand or square knot. •Raise presser foot and cut the needle thread(s) right above the needle eye. •Lower needle bar to its lowest position by turning the handwheel. With the presser foot in the highest position, pull the looper threads until the knots are about 4K past the presser foot. •Rethread your needle(s). 18
TESTING STITCH After threading is completed, test your Superlock stitch in the following order: 1. Be sure both front cover and side cover are closed. 2. Without fabric under the presser foot, lower presser foot. Pull the ends of the threads gently with your left hand toward the rear of the machine, turning the handwheel toward you a few times to make sure the stitch forms on the stitch finger (figure 1). 3. Sew on scrap fabric. When you reach the end of the fabric, raise the presser foot and remove fabric from your Superlock. Use the handy thread cutter (figure 3) on your Superlock to cut your threads. Use the illustrations on the following pages to check the stitch formation L produced to see if it is uniform. If not, you will need to adjust tensions and/or recheck threading. Fig. 2 Fig. 1 19
Page 1 and 2: WHITE SUPERLOCK OWNERS WORKBOOK 200
Page 3 and 4: SECTION IV - Differential Feed 33 P
Page 5 and 6: I I, SECTION I KNOW YOUR MACHINE -
Page 7 and 8: SUPERLOCK SET UP & MAINTENANCE 1. S
Page 9 and 10: 12. DISENGAGING UPPER CUTTER To low
Page 11 and 12: HINTS FOR SUCCESSFUL STITCHING An u
Page 13 and 14: Needles NEEDLES, THREAD & FABRIC CH
Page 15 and 16: Your White Superlock is very easy t
Page 17 and 18: THREADING LOWER LOOPER Bring the th
Page 19: (For right needle) 0 (For left need
Page 23 and 24: Left Needle Thread Loose and visibl
Page 25 and 26: SUPERLOCK SEAMS & SEAM FINISH Seam
Page 27 and 28: ADJUSTING CUTTING WIDTH & BALANCE O
Page 29 and 30: SECURING BEGINNING & END OF SEAM As
Page 31 and 32: INSIDE CORNERS Practice the inside
Page 33 and 34: RIBBING Your Superlock will finish,

WHITE SUPERLOCK OWNERS WORKBOOK 2000 ATS - Singer

Create successful ePaper yourself

Delete template?

Save as template?