WHITE SUPERLOCK OWNERS WORKBOOK 2000 ATS - Singer

More documents

Recommendations

Info

ADJUSTING CUTTING WIDTH The cutting width can be changed for different techniques and types of fabric. Loosely woven or heavy knit fabrics require a wider width and lighter weight fabrics require a narrower seam width. Machine Settings Fabric Stitch length: 2.5 - 3.0 Stitch width: 6 Medium weight woven Tension Settings Serge Normal Serge along one edge with the stitch width on 4mm. Serge along the other edge with the stitch width at 7mm. For a narrow or wide stitch width, see three thread sewing techniques on pages 38 and 39. 26
SECURING BEGINNING & END OF SEAM As most ends of seams and finished edges are later stitched over during garment construction, it is often not necessary to lock ends. When needed, use one of the following methods. Machine Settings Stitch Length 2.5 - 3 Stitch width 6 Fabric Medium weight woven Tension Settings Normal (LN) -4- (RN) -4- (UL) -4- (LL) -4- Securing Beginning of Seam •Fold fabric in half ‘Stitch 2-3 stitches into fabric, then stop sewing. •Raise presser foot. Bring chain around left side of foot and under front of cutter. ‘Lower presser foot and sew, cutting off excess chain. Securing End of Seam •Sew to end of fabric. ‘Raise presser foot to release thread tensions and pull fabric V from foot. ‘Reinsert fabric under foot about 1 from end and serge over previous stitching. •Raise presser foot and pull sample out. Use thread cutter to cut threads. Optional Securing Methods ‘You may tie a knot in the thread ends. This method requires about three inches of extra thread. After tying knot, trim ends. ‘Use a small amount of Fray CheckTM at the ends. ‘Thread ends into the finished seam. This requires one or two inches of thread at the end and is usually the best choice for decorative finishes. 27
Page 1 and 2: WHITE SUPERLOCK OWNERS WORKBOOK 200
Page 3 and 4: SECTION IV - Differential Feed 33 P
Page 5 and 6: I I, SECTION I KNOW YOUR MACHINE -
Page 7 and 8: SUPERLOCK SET UP & MAINTENANCE 1. S
Page 9 and 10: 12. DISENGAGING UPPER CUTTER To low
Page 11 and 12: HINTS FOR SUCCESSFUL STITCHING An u
Page 13 and 14: Needles NEEDLES, THREAD & FABRIC CH
Page 15 and 16: Your White Superlock is very easy t
Page 17 and 18: THREADING LOWER LOOPER Bring the th
Page 19 and 20: (For right needle) 0 (For left need
Page 21 and 22: TESTING STITCH After threading is c
Page 23 and 24: Left Needle Thread Loose and visibl
Page 25 and 26: SUPERLOCK SEAMS & SEAM FINISH Seam
Page 27: ADJUSTING CUTTING WIDTH & BALANCE O
Page 31 and 32: INSIDE CORNERS Practice the inside
Page 33 and 34: RIBBING Your Superlock will finish,

WHITE SUPERLOCK OWNERS WORKBOOK 2000 ATS - Singer

Create successful ePaper yourself

Delete template?

Save as template?