Recessed Architectural Floodlighting - THORN Lighting

10
D-CO LED and E/Fact Slim 3
Technical Data
LED
(Pre-fixed PCB)
D-CO LED Mini: 1x1.2W
D-CO LED Medi: 1x1.2W
D-CO LED Maxi: 6x1.2W
E/Fact Slim 3: 16x1.2W
Lamps
E/Fact Slim 3:
70W HIT-DE (MD)
Metal halide, cap: Rx7s
Materials/Finish
D-CO LED:
Body: aluminium (for Mini and
Maxi), PC/ABS blend for Medi.
Frame: 316 stainless steel.
Retaining screws: stainless steel.
Glass: toughened glass, frosted
(Mini and Medi), clear (Maxi).
Gasket: anti-ageing silicon.
Recessing box: aluminium (except
Maxi - ABS) with plastic end cap.
Pre-wired cable: H05RN-F, 0.5m
length.
Connection boxes: PC/ABS
blend.
All versions except Mini have
integral power supply.
All versions have electronic
drivers.
E/Fact Slim 3:
Body: LM6 marine grade die-cast
aluminium, powder coated for
further protection.
Frame: 316 Stainless steel (3mm
thick).
Retaining screws: stainless steel.
Glass: 15mm toughened semifrosted.
Gasket: anti-ageing silicon.
Recessing box: polypropylene.
Pre-wired cable: H07RN-F, 0.5m
length.
All versions have integral power
supply.
Electronic driver for LED versions,
magnetic ballast for Metal Halide
version.
Installation/Mounting
For outdoor applications,
30cm drainage gravel or any
equivalent drainage system must
be used beneath the housing to
ensure water can evacuate. The
recessed box can be embedded
in asphalt with good drainage
once the temperature of the
asphalt is approximately 80˚C.
D-CO LED:
Luminaires delivered complete
with body, recess box, frame and
glass. All the fittings are supplied
with 5m cable.
Mini kit luminaires are individually
pre-wired with a 5m cable
and supplied with an 8 way
connection box, containing gear
and connectors – including a
specific connector for through
wiring.
The maximum static load is
500kg.
To facilitate quick installation,
the wiring can be done via IP67
wiring connectors (SAP codes
96257910 or 96257911).
For through wiring, IP67
connection boxes can be used
(SAP code 96257907).
E/Fact Slim 3:
Luminaires delivered complete
with body, recess box, frame and
glass, cable.
Luminaire must be operated for
45 minutes without its front glass
to avoid moisture building up
inside the housing.
The maximum static load is
1000kg.
To facilitate quick installation,
the wiring can be done via IP67
wiring connectors (SAP codes
96257910 or 96257911).
For through wiring, IP67
connection boxes can be
used (SAP codes 96257907,
96257908 or 96257909).
Standards
Designed and manufactured to
comply with AS/NZS 60598
Class I Electrical (E/Fact Slim 3
and D-CO LED Maxi).
Class II Electrical (D-CO LED Mini
and Medi).
IK 09 for E/Fact Slim 3 and
D-CO LED Maxi.
IK 10 for D-CO LED Mini and
Medi.
IP67.