Eldningsinstruktion och bruksanvisning Cronspisen 100, 200, 500 ...

Components in the firebox
Cronspisen 500
The baffles have the task of guiding the smoke gases down
at the sides. Insert the baffle in the front left side flue.
When the baffle is inserted it is angled slightly to the right
so that the curved part is parallel to the insert. Insert the
baffle so that the notch is level with the edge of the hole
in the side of the insert. Hook it into place on the edge of
the insert. Insert a hand into the middle and feel on the
upper side of the insert that both hooks on the curved part
are on the edge. Move the guide baffle backwards until it is
against the curved intermediate wall.
The baffle must hang from the edge of the insert and lie
against the intermediate wall between the front and rear
flues. The same procedure is used to install the right hand
baffle.
21
GB
Insert the smoke baffle and position it on the upper side
of the insert. Move it backwards against the rear wall of
the insert. If it is tight between the upper side of the insert
and the intermediate wall in the body, compress the smoke
baffle a little so that it is lower.
Fix the holders to the vermiculite sheets and install the
sheets on the sides. Slid the sheets as far forward as possible
to the front side of the insert so that the air intake at
the rear is not blocked. Insert the rear vermiculite sheet in
the U profile furthest in. Then stand it vertically on the cast
iron bottom.
HK