Surgical Technique International Version

More documents

Recommendations

Info

4.5mm Cortex and Locking Screw insertion Pass a 4.5mm Screw/3.2mm Drill Guide assembly through the targeter base and into the desired screw hole in the plate shaft. Tighten the Drill Guide into the plate and drill accordingly with Long 3.5mm Drill Bit (7117-3402). Measure for screw length by reading the exposed calibrations off the drill bit. Remove the drill bit and Drill Guide. Insert the appropriate length 4.5mm Cortex or Locking Screw using the 3.5mm Hexdriver Shaft (7117-3409) and Large Quick Connect Handle. Note Screws may be inserted on power, but should always be tightened by hand in order to avoid loss of reduction, stripping of the screw head or damage to the screwdriver. Fill remaining screw holes as desired. 26
Targeter removal Remove all provisional fixation pins and screw guide sleeves still in place. Loosen the locking nut by rotating the Locking Tool counter-clockwise. Remove the Drill Guide. Extract the targeter assembly from the incision taking care to prevent the connecting bolt from falling out of the targeter. 27
Page 1: Surgical Technique International Ve
Page 4 and 5: Product overview Introduction Proxi
Page 6 and 7: PERI-LOC Proximal Femur case exampl
Page 8 and 9: PERI-LOC PFP implant overview PERI-
Page 10 and 11: Surgical technique Patient position
Page 12 and 13: Open technique Alpha hole Guide Pin
Page 14 and 15: In the lateral view, verify the cor
Page 16 and 17: Beta hole Guide Pin insertion Threa
Page 18 and 19: 5.7mm Cannulated Locking Screw inse
Page 20 and 21: 4.5mm Locking Screw Thread a 3.5mm
Page 22 and 23: Percutaneous technique using radiol
Page 24 and 25: Alpha hole Guide Pin insertion Inse
Page 26 and 27: Screw insertion 6.5mm Cannulated Sc
Page 30 and 31: Closure Obtain final AP and lateral
Page 32 and 33: Catalogue information PERI-LOC Inte
Page 34: Notes 32

Surgical Technique International Version

Create successful ePaper yourself

Delete template?

Save as template?