standoffs - Amatom

SWAGE STANDOFFS
SWAGE TYPE ROUND • HEX STANDOFFS 5/32"
All Swage type standoffs through 1" long can be supplied as a swage type spacer. Pick out the diameter, length and swage you
need; find the part number and change the thread to hole size. Example: You need a 1/4 OD brass x 1/2 long body for a 1/16 board
with clearance for a no. 6 screw. Standard part number is 9537B-B-0632. Change part number to 9537B-B-140.
Use chart on page 5 to determine correct clearance hole code
Please Note: Selected Hole size cannot be larger than counterbore diameter.
5/32" 5/32"
PART NUMBER
ORDERING SYSTEM
XXXXX - X - XXXX- XX
PART NO. MATERIAL FINISH
SHANK
THREAD
X = LENGTH OF SHANK ±.003
T = THICKNESS OF PANEL
A = LENGTH OF STANDOFF ±.005
5/32″ 5/32″
A Part No.
Length Round Hex
1/8 9505 9598
3/16 9506 9599
1/4 9507 9600
5/16 9508 9601
3/8 9509 9602
7/16 9510 9603
1/2 9511 9604
9/16 9512 9605
5/8 9513 9606
11/16 9514 9607
3/4 9515 9608
7/8 9516 9609
1 9517 9610
SHANK/BOARD THICKNESS CODE
X T
Shank Board Code
±.003 Thickness
.075 1/32 A
.105 1/16 B
.135 3/32 C
.165 1/8 D
.230 3/16 E
.290 1/4 F
Refer to page 4 for Thread Depth.
Refer to page 7 for installation instructions.
Refer to page 8 for Finish Codes.
For parts not listed contact sales office.
MATERIAL CODE
Aluminum A
Brass B
Steel S
Stainless Steel SS
THREAD CODE
THREAD CODE
2-56 0256
5 Pasco Hill Road • Cromwell, CT 06416-1093
Phone: 860-828-0847 • Call Toll Free: 800-243-6032 • Fax: 860-828-0381
Web Address: http://www.amatom.com • E-Mail: sales@amatom.com
.098
5/32 .125
Break
Edge
X = LENGTH OF SHANK ±.003
T = THICKNESS OF PANEL
A = LENGTH OF STANDOFF ±.005
Round Swage Tooling
Body
Punch Anvil Length
PSP 638 PSA 139-1 1/8-3/16
139-2 1/4-7/16
139-3 1/2-11/16
139-4 3/4-1"
Hex Swage Tooling
Body
Punch Anvil Length
PSP 638 PSA 139-1H 1/8-3/16
139-2H 1/4-7/16
139-3H 1/2-11/16
139-4H 3/4-1"
21
SWAGE STANDOFFS