standoffs - Amatom

PLEASE READ THIS CAREFULLY
SCREWS - EXPLANATION OF AMATOM PART NUMBERS
61XX – B – 0440 – 4
This number indicates the style and
length of the screw. The number for
each different length in any one
style is the same for all head sizes.✝
(Head size is determined by thread
size unless otherwise specified as in
Note 3 below.) ✝Except type 2.
This letter indicates the material
from which part is made. (See chart
A, page 66.)
This number designates the thread
size. Thread size determines all
dimensions of screw, except length,
unless otherwise specified. (See
Chart B, page 66.)
5 Pasco Hill Road • Cromwell, CT 06416-1093
Phone: 860-828-0847 • Call Toll Free: 800-243-6032 • Fax: 860-828-0381
Web Address: http://www.amatom.com • E-Mail: sales@amatom.com
This number designates the finish of
the part. Customer must add this
number. (See Chart C, page 66.)
Notes: 1. Standard finishes are stocked as listed under each type. If other than standard finishes are required, see Chart C page 66.
2. For screws with unslotted heads, add the letter U after the first four digits as follows - 61XXU.
SPECIAL SIZES:
For parts not listed in this catalog, please send a print to Amatom’s Sales Office. Some typical modifications include:
– Different Length, Dimension “L”.
– Different Combinations of Head Sizes and Thread Sizes.
RETAINERS - EXPLANATION OF AMATOM PART NUMBERS
62XX – A – B – 0440 – 4
This number indicates the
style and size of the
retainer (see tables.)
This letter designates the
shank length (see tables.)
This letter indicates the
material from which part
is made (see Chart A.)
This number designates
the thread size of the
screw used with the
retainer (see Chart B.)
Notes: 1. Standard finishes stocked are as listed under each type. If other than standard finishes are required, see Chart C page 66.
2. For special shank lengths contact Amatom Sales Office.
SHANK LENGTH -
RETAINERS
The same system has
been followed with the
addition of letters “A”
through “E” added to
the number designating
the length of the shank
- as follows:
Note: For special shank
lengths contact Sales Office.
TABLE 15
Type 1
CODE FOR
SHANK LENGTH (A DIM.)
LENGTH PANEL
CODE OF SHANK THICKNESS
A .050 .048-.072
B .080 .074-.109
C .125 .119-.156
D .188 .188
E .250 .250
Part Number Code
and Specifications
TABLE 17
Type 2A-B-C-D Type 3
CODE FOR
SHANK LENGTH (A DIM.)
LENGTH PANEL
CODE OF SHANK THICKNESS
A .062 .052-.067
B .093 .084-.099
C .125 .109-.140
D .187 .171-.203
E .250 .234-.265
This number designates
the finish of the part.
Customer must add this
number.
(See note below.)
TABLE 26
Type 3A
CODE FOR
SHANK LENGTH (A DIM.)
LENGTH PANEL
CODE OF SHANK THICKNESS
A – .052-.067
B – .084-.099
C .165 .109-.140
D .230 .171-.203
E .290 .234-.265
65
CAPTIVE PANEL HARDWARE