Douglas in full lengths - Dinesen

More documents

Recommendations

Info

Check list 1. Never have the floors delivered before the house is closed, dry and warm, and the humidity levels are under control. 2. Carry the planks into the house upon delivery and never, under any circumstances, leave them out- side for the night. 3. Normally, the planks can be installed immediately, but during the winter, they should be left in the room for 24-48 hours prior to installation. 4. Keep an eye on the temperature and humidity levels. If the planks are stored at a humidity level above 50% RH, they will absorb moisture and thus expand. This will eventually cause larger contraction cracks than would normally be expected. 5. Be absolutely sure that the concrete is dry. Measure the moisture level. Concrete moisture may destroy wooden floors. See Dinesen humidity instructions. 6. During installation, remember to consider colour and veins of the wood. The aim is to arrange the floor in a way so that the result is harmonious. 7. Sand all Dinesen floors prior to finishing. 8. An ordinary shuffle sander or rotary sander are not appropriate tools for sanding of large surface areas. Contact a professional floor expert or Dinesen. 9. For floor heating - see Dinesen floor heating instructions. 10. Use only Dinesen products or products approved by Dinesen for finishing. And see Dinesen finishing instructions. 11. Dinesen’s warranty does not apply to damages caused by construction humidity. 12. Dinesen does not accept complaints about the visual appearance of individual planks after installation. 13. Remember always to contact Dinesen if you have questions about installation or finishing. Page 18 I Check list
Instructions If you need further advice, please contact Dinesen at +45 7455 2140, where you can also order and buy the Dinesen range of maintenance products for wooden floors. Dinesen Klovtoftvej 2, Jels DK-6630 Rødding T +45 7455 2140 info@dinesen.com www.dinesen.com Advice about floors, installation and maintenance Insulation of crawl ways etc. Rockwool +44 1656 8626 21 Floor heating, water-based Uponor +44 1455 5503 55 Floor heating, electrical DEVI +44 8454 3499 91 Chair Mat Fraster +45 8788 2244 Dinesen Instructions 01 Dinesen installation instructions for Douglas floors in full lengths 02 Dinesen installation instructions for Douglas floors in decreasing lengths 03 Dinesen installation instructions for oak floors in decreasing lengths 04 Dinesen humidity instructions 05 Finishing and caring for Dinesen floors 06 Dinesen floors and floor heating Video instructions (sanding, finishing, caring) www.video.dinesen.com Dinesen’s instructions are based on Danish building codes and regulations, reservations are therefore made for national code of practice. Other products and construction parts require the knowledge and insight of a specialist.Note that guidance besides our own product is beyond our service. Reservations are made for printing errors. Instructions I Page 19
Page 1: 01 English Installation instruction
Page 4 and 5: General notes • The building must
Page 6 and 7: 8. If the planks are tapered, distr
Page 8 and 9: Installation on concrete 1. Check t
Page 10 and 11: Figure 5: Cross section, screwed fr
Page 12 and 13: 9. Glue the plugs carefully with mo
Page 14 and 15: Installation on concrete - screwed
Page 16 and 17: Figure 13: Cross section, secretly

Douglas in full lengths - Dinesen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?