Instruction manual - Sig Sauer
Instruction manual - Sig Sauer
Instruction manual - Sig Sauer
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
english<br />
7. Changing the barrel<br />
There are 8 caliber groups available (see<br />
table on page 42). When changing the<br />
barrel to a different caliber group, you<br />
will also have to change the bolt head to<br />
suit the caliber group of the barrel you<br />
have chosen to use. The table on page<br />
42 shows the correct components to be<br />
used together. In addition, bolt heads<br />
and barrels are stamped with markings<br />
which identify the caliber group (fig. 11).<br />
Take a final check that these markings<br />
match after the rifle is assembled.<br />
Caliber group markings:<br />
Hornet Marking HO<br />
Mini Marking MI<br />
Standard Marking ST<br />
Medium Marking ME<br />
Magnum Marking MA<br />
Ultra Magnum Marking UM<br />
Swiss Marking CH<br />
Shotgun Marking 28<br />
12<br />
Make sure you also use the correct<br />
magazine to match the caliber of the<br />
barrel. The caliber marking can be<br />
found on the side of the magazine.<br />
Note: Single-shot inserts are supplied<br />
with barrels in the calibers .22 Hornet,<br />
28/70 and 10.3x60R. Magazines are not<br />
available for these.<br />
Changing the barrel:<br />
- Unload the rifle (see chapter 5).<br />
- Remove the bolt assembly<br />
(see chapter 6.1).<br />
- Remove the magazine (remove the<br />
scope if fitted, see chapter 12.2 or<br />
13.2 as appropriate).<br />
- Fully undo both attachment screws<br />
with the 4 mm AF allen key, these are<br />
captive so cannot be lost.<br />
- Lift the barrel out of the receiver.<br />
- Place the new barrel in the bed of the<br />
receiver.<br />
- Tighten both barrel attachment<br />
screws hand-tight with the allen key.<br />
fig. 11<br />
MA<br />
- Insert a magazine matching the caliber<br />
of the barrel into the magazine housing.<br />
- Check that the marking stamped on<br />
the bolt head (HO, MI, ST, ME, MA,<br />
UM, CH, 28, see chapter 7 and fig.<br />
11) matches the caliber group of the<br />
barrel.<br />
- If you have to change the bolt head in<br />
the bolt assembly, see chapter 8.<br />
Note:<br />
Always keep the barrel bedding clean.<br />
Excessive oil or grease between the barrel<br />
and receiver will impair the accuracy of<br />
the rifle.<br />
MA