Hiniker 9850 Manual - Snow Plow Stuff
Hiniker 9850 Manual - Snow Plow Stuff
Hiniker 9850 Manual - Snow Plow Stuff
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
DWG. NO. 5849<br />
Refer to drawing 5849. Attach the ring terminal<br />
of the solid red (or red striped) wire of the<br />
power cable assembly to the terminal on the<br />
motor at location 1.<br />
Fasten the ring terminal of the solid black wire<br />
of the power cable assembly, the black wire<br />
with the ring terminal on the plow harness, and<br />
the ring terminal of the ground wire harness to<br />
the terminal on the motor at location 2.<br />
Attach the coil ground wire harness as<br />
shown.<br />
DWG. NO. 6013<br />
Refer to drawing 6013. Use a plastic tie strap<br />
to band the plow wiring harness to the lift<br />
frame tube at location 3. Route wires to the<br />
power unit and headlamps, as shown.<br />
V-<strong>Plow</strong> Assembly 17<br />
DWG. NO. 5844<br />
Connect the Tan wire of the wiring harness<br />
to the spade terminal on solenoid S1.<br />
Connect the Pink wire to solenoid S2.<br />
Connect the Gray wire to solenoid S3.<br />
Connect the Brown wire to solenoid S4.<br />
Connect the Blue with White stripe wire to<br />
solenoid S5.<br />
Connect the Blue wire to solenoid S6.<br />
Connect the RH headlamp to the harness<br />
end labeled “PSNGR SIDE” and the<br />
LH headlamp to the end labeled “DRIVER<br />
SIDE”.