Pallet Jack - Menards

• Handle Assembly Instructions:
1. Important note: The spring of the pallet jack is held in place with a pin (pin B). Do not
remove this pin. Please follow instructions on when this pin should be removed.
2. Pull out pin shaft (part 23). Please refer to Fig. 1.
Fig. 1 Fig. 2
3. Insert handle tube (part 89) into position A. Connect handle tube and the pump body (part
31) via the pin shaft (part 23). Please note the hole in the center of the pin shaft. The chain
(part 10) from the handle will need to be inserted through this hole in step 5. Make sure
that this pin shaft is aligned into the groove of the pump body. Please refer to Fig. 1 and
parts diagram.
4. Insert cotter pin (part 24) through the other end of the pin shaft (part 23).
5. Position chain (part 10) of the handle tube (part 89) over the pressure roller (part 13) and
through the hole in the center of the pin shaft (part 23). Please refer to Fig. 2 and picture
below.
2