TRADE OF VEHICLE BODY REPAIR - eCollege
TRADE OF VEHICLE BODY REPAIR - eCollege
TRADE OF VEHICLE BODY REPAIR - eCollege
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Module 3– Unit 1<br />
Vector Realignment Systems<br />
With the vector method of pulling, parallel pulling can be carried<br />
out in the following way: first connect the chain to the damaged<br />
part of the car, and then hold the chain tightly in the direction you<br />
wish to pull and adjust the pulling unit or ram to the measured<br />
angle. It is not necessary to have the chain vertically in line with the<br />
direction of pull, but it is lower than 45 degrees: that the chain links<br />
are set in line without any twist: and that the chain between the ram<br />
and chain anchor point should always lean towards the vehicle. As<br />
soon as tension is applied to the chain, safety wires must be fitted in<br />
case the clamp or chain tears away from the main structure of the<br />
car.<br />
Figure 31: Simultaneous Multi-pulls on Two Vehicles<br />
(Vector Pulling)<br />
Figure 32: Recommended Pulling Angle 45º No Lower<br />
Vehicle Body Repairs - Phase 2 44