Y-IM-Single Package AC and Single Package Gas/Electric Units ...
Y-IM-Single Package AC and Single Package Gas/Electric Units ...
Y-IM-Single Package AC and Single Package Gas/Electric Units ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
When fastening ductwork to side duct flanges on<br />
unit, insert screws through duct flanges only. DO<br />
NOT insert screws through casing. Outdoor ductwork<br />
must be insulated <strong>and</strong> water-proofed.<br />
FIGURE 13 - SIDE PANELS WITH HOLE PLUGS<br />
Note orientation. Panel is “insulation” side up.<br />
FIGURE 14 - RETURN DOWNFLOW PLENUM WITH<br />
PANEL<br />
FIGURE 15 - DISCHARGE PANEL IN PL<strong>AC</strong>E<br />
CONDENSATE DRAIN<br />
167690-Y<strong>IM</strong>-B-0606<br />
The side condensate drain is reversible <strong>and</strong> maybe re-oriented<br />
to the rear of the cabinet to facilitate condensate piping.<br />
A condensate drain connection is available through the<br />
base pan for piping inside the roof curb. Trap the connection<br />
per Figure 16. The trap <strong>and</strong> drain lines should be protected<br />
from freezing.<br />
Plumbing must conform to local codes. Use a sealing compound<br />
on male pipe threads. Install condensate drain line<br />
from the 3/4 inch NPT female connection on the unit to an<br />
open drain.<br />
COMPRESSORS<br />
The compressors are mounted on elastomer insulators. The<br />
mounting bolts have been fully tightened for shipping.<br />
FILTERS<br />
! E E K <br />
2 6 1 ) + 1<br />
/ 7 ) 4 ,<br />
FIGURE 16 - CONDENSATE DRAIN<br />
Do not loosen the compressor mounting bolts.<br />
Two-inch filters are supplied with each unit. One-inch filters<br />
may be used with no modification to the filter racks. Filters<br />
must always be installed ahead of evaporator coil <strong>and</strong> must<br />
be kept clean or replaced with same size <strong>and</strong> type. Dirty filters<br />
reduce the capacity of the unit <strong>and</strong> result in frosted coils<br />
or safety shutdown. Refer to physical data tables, for the<br />
number <strong>and</strong> size of filters needed for the unit. The unit should<br />
not be operated without filters properly installed.<br />
Make sure that panel latches are properly positioned<br />
on the unit to maintain an airtight seal.<br />
16 Unitary Products Group