JSC Catalog Vol. 6 - Jones Stephens Corporation

PVC DWV Fittings
PVC/DWV
FITTINGS
340
Fitting C.O. Adapter, w/Plug
Spg x FPT
• Solvent welds into fitting hub to provide access to piping
• Teflon thread tape is recommended for threaded joints
PVC# SIZE MASTER CTN.
PFA615 1-1/2” 50
PFA620 2” 50
PFA630 3” 25
PFA640 4” 10
45 Deg Street Elbow
Spg x Hub
• Used to change direction from a fitting hub to a pipe
• Sometimes called a “St. 1/8 bend”
PVC# SIZE MASTER CTN.
PSL715S 1-1/2” short turn 100
PSL716S 1-1/2” long turn 100
PSL720 2” 50
PSL730 3” 20
PSL740 4” 10
PSL760 6” 3
60 Deg Elbow
H x H
• Used to change direction in piping
• Sometimes called a “OK bend”
PVC# SIZE MASTER CTN.
PFL915 1-1/2” 40
PFL920 2” 25
PFL930 3” 20
PFL940 4” 10
90 Deg Vent Elbow
H x H
• Used to change direction in the “dry” portion of vent piping
where water flow is not a consideration
PVC# SIZE MASTER CTN.
PFL715 1-1/2” 20
PFL720 2” 30
PFL730 3” 10
Jones Stephens Corp. • PlumBest • LTConnections
90 Deg Elbow
H x H
• Used to change direction in piping
• Sometimes called a “1/4 bend”
PVC# SIZE MASTER CTN.
PFL814 1-1/4” 100
PFL815 1-1/2” 100
PFL820 2” 50
PFL830 3” 25
PFL840 4” 10
PFL860 6” 5
PFL821 2” x 1-1/2” 20
PFL834 4” x 3” 20
90 Deg Elbow w/Side Inlet
H x H x Spg/H
• Used to connect a branch line or vent at a change of
direction in a larger vertical or horizontal pipe
• The inlet is constructed to accept a 2” fitting over its
outside diameter or a 1-1/2” pipe into its inside diameter
PVC# SIZE MASTER CTN.
PFL131 3” x 2” Spg or 1-1/2” Hub 20
90 Deg Street Elbow
Spg x H
• Used to change direction in piping
• Sometimes called a “street 1/4 bend”
PVC# SIZE MASTER CTN.
PSL916 1-1/2” 100
PSL926 2” 50
PSL936 3” 20
PSL946 4” 10
90 Deg Long Sweep Elbow
H x H
• Used to change direction in piping
• Sometimes called a “long turn 1/4 bend”
PVC# SIZE MASTER CTN.
PFL815L 1-1/2” 50
PFL820L 2” 25
PFL830L 3” 10
PFL840L 4” 5
Toll Free Phone 1-800-35-JONES (355-6637) • Toll Free Fax 1-800-462-6991 • Website www.plumbest.com