Assembly And Maintenance Instructions – WABCO

Fig. 58
Fig. 59
Fig. 60
Fig. 61
Sliding Calliper Disc Brake PAN 17
21 10
10
1
10
Working sequence for installation:
• Clean the gaiter seat (10) (arrow) in the calliper (fig.
without adjuster screw).
• Push new gaiter (10) over the adjuster screw, centre
it and push down the gaiter into the seat of the calliper
(1) manually (fig. without adjuster screw).
• Grease the gaiter lips (10) and insert the gaiter (10)
into the seat of the adjuster screw (21).
• Visually check gaiter for proper seat.
Note: Ensure that the gaiter lip in the annular groove in
the adjuster screw sits free of folds!
• Install brake pads and set clearence. Carry out according
to section 3 and pay attention to notes.
25