Baader SteelDrive Instruction Manual - Baader Planetarium

More documents

Recommendations

Info

Table of Contents Table of Contents...........................................................................................................................................................2 1. What’s in the Box........................................................................................................................................................3 2. Installing the SteelDrive...............................................................................................................................................3 3. Connecting the SteelDrive for Operation....................................................................................................................6 4. Operating the SteelDrive with the Hand Controller.....................................................................................................7 5. SteelDrive Software and Drivers................................................................................................................................13 6. Installing the Software and Drivers............................................................................................................................13 7. Using SteelGo Controlling Software...........................................................................................................................19 8. Troubleshooting .......................................................................................................................................................23 9. Technical Specifications.............................................................................................................................................25 Page 2 Copyright 2012 BAADER Planetarium GmbH, Mammendorf
1.What’s in the Box The Baader SteelDrive Focuser comes with the following: a. 1 pc SteelDrive unit with aluminium pulley b. 1 pc Transmission Belt c. 1 pc CDROM with drivers, software and instruction manuals d. 1 pc USB cable e. 1 pc Thermo Probe Optional: 12V Baader Outdoor Telescope Power Supply #245 7610 and the 5,5/2,5mm adapter #245 7611, for powering the dedicated Hand Controller. Important Note: The dedicated Hand Controller must be connected to the SteelDrive BEFORE power is connected. 2.Installing the SteelDrive The Baader SteelDrive is straightforward to install on to the Baader Steeltrack focuser without any part of the focuser needing to be removed at all. Installing the SteelDrive to the Steeltrack Focuser 1. Screw out the 4 set screws placed each side of the SteelDrive until the black housing can touch the Steeltrack focuser base where there are placed two small dovetails. You do not need to unscrew them completely, just sufficiently so that the Unit can be placed over the Steeltrack. 2. Screw in the 4 set screws so that they push against the small dovetails. Do not tighten yet. 3. Wrap the belt around the Steeltrack brass gear and SteelDrive pulley. 4. Align the SteelDrive with the Steeltrack by making sure that SteelDrive motor housing is lined up with the flattened face of the Steeltrack focuser as shown below. Page 3 Copyright 2012 BAADER Planetarium GmbH, Mammendorf
Page 1: Baader SteelDrive Instruction Manua
Page 5 and 6: Correct tension is when the belt is
Page 7 and 8: Connecting the SteelDrive to use wi
Page 9 and 10: Important Note: MAKE SURE THE DRAWT
Page 11 and 12: SAVING.. overwritten. Run Mode The
Page 13 and 14: 5.SteelDrive Software and Drivers S
Page 15 and 16: 4. Select INSTALL FROM A LIST OR SP
Page 17 and 18: Please note, the latter two Positio
Page 19 and 20: 7.Using SteelGo Controlling Softwar
Page 21 and 22: POINTING FUNCTIONS SYNC ABSOLUTE [S
Page 23 and 24: 8.Troubleshooting Important Note: T
Page 25: 9.Technical Specifications STEELDRI

Baader SteelDrive Instruction Manual - Baader Planetarium

Create successful ePaper yourself

Delete template?

Save as template?