Centrifugal casting machines - Küttner - Engineering and Contracting

Centrifugal casting machines from Düker – tailored to your individual needs
Top photograph: Casting station.
Bottom photograph: Centrifugal casting frame
We need very few details for planning your system
– simply tell us what products you wish to produce
and in what quantities and the design of any exis-
ting equipment. We will then design the ideal cen-
trifugal casting system for your needs.
Wide range of system types
• Single-station machines for small production
rates and special applications with just one
mould. This machine is flexible enough for a wide
range of products.
• Multi-station machines for mass production
with high quantities per hour. Several moulds
are used in parallel.
• Flange machines (both vertical and horizontal)
for large diameters of up to 3,000 mm with short
product lengths.
Basic layout of a single station machine
Single station machine for truck cylinder liners
Casting discharge device
Modernisation
The installation of a completely new system is
not always the best solution for the needs of the
customer. Therefore we can also modernise
existing systems – regardless of their location.
Modernisation is also a good solution if the
existing system only has to be improved, auto-
mated and fitted with a modern control and
measuring system to meet changed requirements.
It makes no difference to us whether
the existing system was supplied by us or by
another manufacturer.
4 5