tanco autowrap 280 cs operators handbook wd66-280-m0207

Important
- 27 -
Tanco Autowrap 280 CS
Operator’s manual
The above recommendations are only offered as a guide to correct wrapping of silage bales and the manufactures
accept no responsibility for variations that many arise and the consequence of same. They are based upon
turntable speeds of up to 25 r.p.m., and a approx film width of 600mm applied to end bale when using 750mm
wide film roll.
It is the responsibility of the operator to ensure the correct number of wraps are applied, as variances can
occur with fluctuations in speed of rotation, film quality and tensioning, shape and density of bale etc.
11.0 Service and Maintenance
1. All nuts and bolts should be tightened after one hour’s use, thereafter regularly.
2. Wheel pressure should be normally kept at 42 psi depending on bale weight and field
conditions.
3. Inspection moving parts for wear on daily basis.
4. Lubrication
Drive chain & sprocket Grease every 24 hours
Main rollers Grease every 24 hours
Hinge pins on lift Grease every 24 hours
Hinge pins on main tip frame Grease every 24 hours
Hydraulic rams Grease every 24 hours
Film spool assy Grease every 24 hours
Dispenser gearboxes One shot of Grease every,
500 bales. See 6
Main spindle Grease even 4000-5000
bales
5. Adjustments
Turntable drive chain: Adjust after first days work then check/adjust every 50 hours. See Fig.
8
Gearbox Drive chain: Adjust after first days work then check/adjust every 50 hours. See Fig.
2
Roller Drive chain: Adjust after first days work then check/adjust every 50 hours. See Fig.
3
Main Bale Belt: See belt tracking instructions.
6. Film Dispenser
Apply P.T.F.E. based grease to gears every 2 to 3 months.
7. Film Adjustment
Centre of film roll must be in line with centre of bale and the film mast should be vertical.