32 Solution Parameters Analysis job parameters for SOL700 are grouped under the Solution Parameters form accessible from the Solution Type button of the Analysis application form. All contain default values. If the default value is used the parameter is not stored in the database. The supported parameters are shown in the following table: Form Parameters Execution Control Parameters General Parameters Contact Parameters Binary Output Database File Parameters DYSTATIC, DYBLDTIM, DYINISTEP, DYTSTEPERODE, DYMINSTEP, DYMAXSTEP, DYSTEPFCTL, DYTERMNENDMAS, DYTSTEPDT2MS DYLDKND, DYCOWPRD, DYCOWPRP, DYBULKL, DYHRGIHQ, DYRGQH, DYENERGYHGEN, DYSHELLFORM, DYSHTHICK, DYSHNIP DYCONSLSFAC, DYCONRWPNAL, DYCONPENOPT, DYCONTHKCHG, DYCONENMASS, DYCONECDT, DYCONIGNORE, DYCONSKIPTWG DYBEAMIP, DYMAXINT, DYNEIPS, DYNINTSL, DYNEIPH, DYSTRFLG, DYSIGFLG, DYEPSFLG, DYRLTFLG, DYENGFLG, DYCMPFLG, DYIEVERP, DYDCOMP, DYSHGE, DYSTSSZ, DYN3THDT In addition, the Dynamic Relaxation form defines the DAMPGBL entry. All the above mentioned forms appear after selecting one of the buttons of the following form: This form is available under the following solutions: Defines DAMPGBL
CHAPTER 3 Analysis Preferences From Explicit Nonlinear: For <strong>MSC</strong>.Nastran Explicit Nonlinear, select Analysis->Analyze->Solution Type and follow the steps shown in the picture below. Opens “Sol700 Parameters and Extra Data” form 33