SMCNAS02

More documents

Recommendations

Info

10 NOTE: If you have two hard disk drive installed, remove the hard disk drive on the left slot first, then remove the hard disk drive on the right slot. Step 2. Connect to the Network 1. Make sure that the computer is connected to a router. 2. Connect one end of the Ethernet cable to the network connector (LAN) on the back of your storage system (NAS) and the other end to a router. Or you can connect both your computer and storage system (NAS) to one switch, and this switch is connected to the network which has a DHCP server.
Step 3. Connect to Power 1. Make sure that your storage system is turned off (Power switch on the “O” position). 2. Plug the DC cord of the AC adapter to the power connector (DC IN) on the rear of the storage system (). 3. Plug the female end of the AC power cord to the AC adapter and the male end to an electrical outlet (). CAUTION: When you disconnect the AC adapter, disconnect from the electrical outlet first and then from the storage device. A reverse procedure may damage the AC adapter or the storage device. When unplugging the connector, always hold the plug head. Never pull on the cord. Step 4. Configure Your Storage System See the next chapter for the software configuration instructions. 11
Page 1 and 2: TigerStore 2 Bay Network Attached S
Page 3 and 4: TRADEMARKS All brand and product na
Page 5 and 6: This warranty is void if: • The p
Page 7 and 8: Table of Contents vi Important Note
Page 9 and 10: Chapter 1 Introduction Your SMCNAS0
Page 11 and 12: 1.2 Specifications Hardware NOTE: S
Page 13 and 14: Ref Component Description Device I
Page 15 and 16: Chapter 2 Setting Up Step 1. Instal
Page 17: 5. Slide the second hard disk drive
Page 22 and 23: 3.1 Installing and Starting the Sto
Page 24 and 25: 4. Click Finish when the following
Page 26 and 27: 7. Select the destination to instal
Page 28 and 29: 11. The progress of installation wi
Page 30 and 31: 14. The following screen appears. 2
Page 32 and 33: For Apple Mac OS X (10.4.11 or abov
Page 34 and 35: 5. The Easy Install on “iDisk HD
Page 36 and 37: 9. To get the latest font library,
Page 38 and 39: 12. Click the NAS Discovery Utility
Page 40 and 41: System Power-on Without Hard Disk D
Page 42 and 43: 18. When the hard disk drive appear
Page 44 and 45: 21. The following screen appears, t
Page 46 and 47: 23. If you use the default mode (JB
Page 48 and 49: 26. After rebooting, log in by root
Page 50 and 51: 29. System will start to format the
Page 52 and 53: 32. Then click Upgrade. The followi
Page 54 and 55: 35. When the following screen appea
Page 56 and 57: 3. After logging in the following s
Page 58 and 59: 7. After rebooting it will display
Page 60 and 61: 10. System will start to format the
Page 62 and 63: 13. Then click Upgrade. The followi
Page 64 and 65: 16. When the following screen appea
Page 66 and 67: 2. When the following screen appear
Page 68 and 69:
3. The system automatically scans t
Page 70 and 71:
System Setting Allow you to specify
Page 72 and 73:
Network Setting Allow you to config
Page 74 and 75:
66 To change this . . . o this . .
Page 76 and 77:
68 Select “Passive” when you en
Page 78 and 79:
Click File and the following screen
Page 80 and 81:
72 NOTE: If you use Filezilla v2.2
Page 83 and 84:
3.4 Users & Groups Page Displays a
Page 85 and 86:
For Windows/Mac OS X Users (CIFS) 5
Page 87 and 88:
7. Click Remove and the following s
Page 89 and 90:
10. The following screen appears. N
Page 91 and 92:
6. Click Shared Folders and the fol
Page 93 and 94:
8. Select the authorized user(s) an
Page 95 and 96:
2. Click Add and the following scre
Page 97 and 98:
To change this . . . Do this . . .
Page 99 and 100:
Add Shared Folder 2. Click Add to c
Page 101 and 102:
6. You can Add (specify as Read-Onl
Page 103 and 104:
3.7 Advanced Page Provides access t
Page 105 and 106:
NOTE: If your SMTP email server ha
Page 107 and 108:
4. When the confirmation message ap
Page 109 and 110:
iTunes Server Allows your storage s
Page 111 and 112:
5. The below image shows how the iT
Page 113 and 114:
To change this . . . Do this . . .
Page 115 and 116:
3. Proceed to adding a new printer
Page 117 and 118:
UPS Allow your storage system to us
Page 119 and 120:
USB Backup Allow you to backup the
Page 121 and 122:
6. Select the shared folder (e.g. U
Page 123 and 124:
Eject USB Storage Device 1. To ejec
Page 125 and 126:
Download Station Allows peer-to-pee
Page 127 and 128:
119
Page 129 and 130:
7. Click Download Status and the fo
Page 131 and 132:
System Log Display a list of events
Page 133 and 134:
3. Click Shut Down and the followin
Page 135 and 136:
3. Click Reboot and the following s
Page 137 and 138:
2. When the confirmation message ap
Page 139 and 140:
Chapter 4 Map Shares Windows PC You
Page 141 and 142:
2. The following screen appears. Ke
Page 143 and 144:
Chapter 5 Using One-Touch Backup Yo
Page 145:
To use the One-Touch Backup functio
Page 148 and 149:
At Windows XP Portion You must ren
show all

SMCNAS02

Create successful ePaper yourself

Delete template?

Save as template?