TigerAccess Extended Ethernet System - SMC

BASIC CONFIGURATION
switch will broadcast a request for IP configuration settings on the next
power reset. Otherwise, click “Restart DHCP” to immediately request a
new address.
Note: If you lose your web management connection, use a console
connection and enter “show ip interface” to determine the new
switch address.
Command Line Interface
Specify the management interface, and set the IP Address Mode to DHCP
or BOOTP.
Console#config
Console(config)#interface vlan 1 3-69
Console(config-if)#ip address dhcp 3-52
Console(config-if)#end
Console#ip dhcp restart 3-53
Console#show ip interface 3-55
IP address and netmask: 10.1.0.1 255.255.255.0 on VLAN 1,
and address mode: User specified.
Console#
2-13