Automation Engine Reference Guide - Esko Help Center

Miter Ratio
Automation Engine
Determines when a sharp corner is beveled. If the Distance from the base of the trap to the corner
point is larger than the miter ratio multiplied by the trap distance then the corner will be beveled,
otherwise it will remain sharp. This option is only available when mitered corners are selected (default
value 2).
To Ink
Specifies the ink to which the selected color will be added. This ink is typically Process Black.
An alternative process or PANTONE ink name may be entered in this input field, to enrich colors
containing that specific ink.
Minimal Density
Specifies the minimum percentage of 'To Ink' needed in an area before the specified color will be
added to that area. The default percentage is 100%, which means that the selected color will be
added to areas containing 100% of the 'To Ink'.
6.36 Expand Variable Data to PPML File
The Expand Variable Data to PPML File task performs expansion of the specified database entries
into the corresponding graphical output and comes in two variations; one for the PackEdge workflow
and one for the DeskPack workflow.
The Expand Variable Data to PPML File is used for the PackEdge and Plato workflow. The input file
is a PDFPLA file. The ticket allows you to set all variable data parameters.
In the Expand Variable Data to PPML File (DeskPack only) ticket, only the output location and a file
name can be specified. This task is only used for expansion executed from within stepX.
223
6