owner's manual - Villeroy & Boch

Installation and Setup
12
Converting from Single Wire Service to Dual Wire Service:
Diagram is is for for one one 16A 16A or one or
one 32A service. 32A service. For 16A For service, 16A
service, DIP switch DIP A2 switch should be A2 set to
should the “Low be Amp” set to or “Off” the “Low
Amp” setting. setting. For 32A service, For 32A DIP
service,
switch A2
DIP
may
switch
be set to
A2
the
may
be set to the “High Amp”
“High Amp” setting.
setting.
Step 1: Remove the white
wire connecting pins J26
and J23.
Step 2: Insert and secure the second brown wire into the #1 slot of the terminal block and the second blue wire into the #2 slot
of the terminal block.
NOTE: DIP Switch A2 should be set to the “High Amp” setting.
Converting from Single Wire Service to 3-Phase Service:
The 3-phase service MUST
include a neutral wire.
Step 1: Remove the white
wire connecting pins J26
and J23.
Step 2: Remove the blue
wire connecting pins J57
and J28.
Step 3: Move the brown
wire to J28.
NOTE: DIP Switch A2 should
be set to the “High Amp”
setting.
Stereo
Port
J4
Installation and Setup