Freezerator GAF Z21XXMK00 Gladiator Series Service Manual

More documents

Recommendations

Info

c) Disconnect the wire connector from the motor. Motor Connector 3-14 5. To remove the ambient bimetal: a) Unclip the bimetal from the compressor process stub. NOTE: When reinstalling the bimetal on the process stub, keep the bimetal as close to the compressor as possible. b) Follow the instructions supplied with the replacement bimetal to connect it to the unit. Ambient Bimetal
REMOVING THE RELAY/OVERLOAD AND RUN CAPACITOR ASSEMBLY AND THE COMPRESSOR Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Unplug refrigerator or disconnect power. 2. Pull the refrigerator away from the wall. 3. Remove the unit compartment cover (see step 3 on page 3-13 for the procedure). 4. To remove the relay/overload and run capacitor assembly from the compressor: a) Unclip the wire spring retainer from the relay/overload and run capacitor assembly and remove it. Wire Spring Retainer 3-15 b) Pull the relay/overload and run capacitor assembly from the compressor pins. c) Disconnect the 2-pin connector from the relay/overload and run capacitor assembly. 2-Pin Wire Connector d) Pull the run capacitor off the relay/ overload. Run Capacitor Relay/Overload Relay/Overload & Run Capacitor Assembly Continued on the next page.
Page 1 and 2: CONSUMER SERVICES TECHNICAL EDUCATI
Page 3 and 4: TABLE OF CONTENTS Page GENERAL.....
Page 5 and 6: Electrical Shock Hazard Disconnect
Page 7 and 8: MODEL & SERIAL NUMBER DESIGNATIONS
Page 9 and 10: SPECIFICATIONS MODEL NUMBER GAFZ21X
Page 11 and 12: THEORY OF OPERATION The Gladiator G
Page 13 and 14: COMPONENT ACCESS This section instr
Page 15 and 16: 10. Remove the screw from the top c
Page 17 and 18: REMOVING THE AUXILIARY HEATER Elect
Page 19 and 20: 5. To remove the door switch: a) Di
Page 21 and 22: d) Remove the four hex-head rear br
Page 23 and 24: REMOVING THE BOTTOM COMPARTMENT THE
Page 25: REMOVING THE CONDENSER FAN MOTOR AN
Page 31 and 32: 8. To remove a front roller: a) Rem
Page 33 and 34: Before testing any of the component
Page 35 and 36: AUXILIARY HEATER Electrical Shock H
Page 39 and 40: DIAGNOSTICS & TROUBLESHOOTING DIAGN
Page 41 and 42: WIRING DIAGRAMS & STRIP CIRCUITS WI
Page 43 and 44: STRIP CIRCUITS DEFROST (TOP COMPART
Page 45 and 46: — NOTES — 6-5
Page 47 and 48: PRODUCT SPECIFICATIONS AND WARRANTY

Freezerator GAF Z21XXMK00 Gladiator Series Service Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?